![background image](http://html1.mh-extra.com/html/intellitec/lpl822/lpl822_owners-manual_2074941001.webp)
Operation
Washing: 20 Seconds
1. Press the Wash Button. The lens will illuminate green and begin to blink.
2. Wash your hands using warm water and soap as the green LED
Light/Timer
is blinking. The speed of the green flashing light
indicates your progress: it will blink faster as you get closer to finishing.
3. The lens will turn red when the time is up.
Brushing: 2 Minutes
1. Press the Brush Button. The lens will illuminate green and begin to blink.
2. Brush your teeth using your favorite toothpaste as the green LED
Light/Timer
is blinking. The speed of the green flashing light
indicates your progress.
3. The lens will turn red when the time is up.
NOTE:
If you accidentally press the wrong button, simply press the rest button to reset the unit.
Mounting the Timer
Hook and Loop Tape (included):
1. Check the location of where you want to place the Timer. Make sure it is clean and that there is no debris or dust.
2. Remove the suction cup from the back of the bracket by sliding it down and pulling it away from the bracket.
3. The two sides of the hoop and loop tape come pre-attached for ease of mounting. Remove the paper covering on one sticky
side of the tape.
NOTE:
Hook and loop tape may be cut to desired size for easier removal.
4. Place the tape in the recessed area in the center on the back of the Mounting Bracket.
5. Remove the paper covering on the other sticky side of the tape.
6. Place the Mounting Bracket in the desired location. Press firmly and hold for five (5) seconds so that the tape adheres to
the surface.
CAUTION:
Be cautious of what surface the hook and loop adhesive is attached to, as it may remove paint or damage surface.
Screw (included):
You can secure the Timer mounting bracket to almost any surface using a screw. To do so, remove the Timer from the bracket by
sliding it up and out of the bracket.
1. Drill a pilot hole in the location where you want to mount the Timer. Place screw (included) in pre-drilled hole. Tighten slightly
until secure, but do not tighten all the way. Slide the Mounting Bracket keyhole slot over screw head and into position.
2. Tighten screw to secure mounting bracket to wall. Take care to not over tighten.
3. Place the Timer in the mounting bracket.
Suction Cup (included):
Use the suction cup to secure the mounting bracket to surfaces such as tile.
1. Slightly moisten the suction cup and press it onto the mounting surface.
2. The suction cup has a small pull tab for ease of release from mounting surface.
NOTE:
If suction cup releases from mounting surface over time, repeat step 1 above.
LED “WASH & BRUSH” TIMER
LPL822 Owner’s Manual
1
2
3
4
5
6
Location of Controls:
1. Wash Button
2. Brush Button
3. LED Light
4. Reset Button
5. Mounting Bracket
6. Battery Compartment*
Unit requires 3 x 1.5V
AAA Batteries (not included)
*On back of unit
Mounting Bracket
Hook & Loop
Tape Area
Keyhole
Slot
LPL822 Manual.indd 2
4/20/11 11:11:18 AM