Three screws (provided)
QUICK SETUP GUIDE
13.8 Cu.Ft. Upright
Freezer
NS-UZ14XWH7 / NS-UZ14XWH7-C
Before using your new product, please read these instructions to prevent any damage.
PACKAGE CONTENTS
• 13.8 cubic foot upright freezer
• Door handle and screws
• Bottom decorative cover and screws
•
Quick Setup Guide
FIND YOUR
USER GUIDE
ONLINE!
Go to www.insigniaproducts.com, enter your model
in the search box, then press
ENTER
. Next to
Features
, click
Support & Downloads
, then next to
User Guide
, click the language you want.
SETTING UP YOUR FREEZER
Before using your freezer
• Remove the exterior and interior packing.
• Let the freezer stand upright for approximately two hours
before connecting it to power.
• Wipe the inside.
• When moving your freezer, do not tilt it beyond 45° from
upright.
Finding a suitable location
• This freezer is designed to be free standing only, and
should not be recessed or built-in.
• Place your freezer on a floor that is strong enough to
support the freezer when it is fully loaded.
• Allow 7.9 inches (20 cm) of space between the sides of the
freezer and the walls, 3.9 inches (10 cm) between the back
of the freezer and the wall, and 11.8 inches (30 cm)
between the top of the freezer and the ceiling.
• If you locate the freezer next to a fixed wall, allow sufficient
space on the hinge side for the door to swing open.
• Locate the freezer away from direct sunlight and sources of
heat, such as a stove, heater, or radiator. Direct sunlight
may affect the acrylic coating and heat sources may
increase electrical consumption. Extremely cold tempera-
tures may also prevent the freezer from performing
properly.
• Avoid locating the freezer in moist areas.
Leveling your freezer
• If the feet are not adjusted during installation, the doors
may not close or seal properly, causing cooling, frost, or
moisture problems.
• To level your freezer, rotate the leveling feet clockwise (to
raise) the freezer or counter-clockwise (to lower). The front
of the freezer may be slightly higher than the back.
Installing the door handle
1
Unplug the freezer.
2
Screw the extended-head screws into the door holes using
the included wrench. Do not overtighten. The screw heads
should extend above the surface of the door.
3
Place the door handle over the heads of the screws.
4
Install the remaining two screws into the holes in the side
of the handle, then tighten them securely.
Installing the bottom decorative cover
1
Remove the cover plate on the hinge side of the decorative
cover.
2
Install the bottom decorative cover by using the three
screws provided.
Final flat size: 406.4 × 266.7 mm Final folded size: 203.2 × 266.7 mm
USING YOUR FREEZER
1
Plug in your freezer. Wait for 30 minutes, then open the
freezer door to determine if the freezer is working properly.
2
Press and hold the
Lock
button for three seconds, then
+
or
-
to set the temperature inside the freezer. A beep sounds
when the MAX or MIN temperatures are reached.
Using the Lock button
• To prevent accidental activation, the control panel
automatically locks after a period of inactivity. To use the
control panel, press and hold the
Lock
button for three
seconds.
Switching between Freezer and Refrigerator modes
This freezer has an advanced design feature that lets you
change it from a freezer to a refrigerator.
1
Press and hold the
Lock
button for three seconds.
2
Press and hold the
Freezer/Fridge
button for three
seconds. The panel beeps and the indicator changes to the
new mode.
Quick Freezing foods
• The quick freeze mode lowers the temperature below the
normal operating temperature to quickly freeze foods. Press
the
Quick Freeze
button to enter quick freeze mode. The
blue snowflake turns on.
• The quick freeze mode turns off after three hours if the
temperature falls below -13° F (-25° C). If the temperature
does not fall below -13° F (-25° C), the quick freeze mode
turns off after 24 hours. You can press the button a second
time to exit quick freeze mode.
Switching between Fahrenheit and Celsius
1
Press and hold the
Lock
button for three seconds.
2
Press and hold
+
and
-
at the same time for three seconds.
A beep sounds and the display changes.
Cover plates (remove one)
NS-UZ14XWH7_NS-UZ14XWH7-C_19-0026_QSG_V7_EN.ai 1 1/28/2019 11:20:12 AM
NS-UZ14XWH7_NS-UZ14XWH7-C_19-0026_QSG_V7_EN.ai 1 1/28/2019 11:20:12 AM
