Instruction Manual
Option Attachment “OPC-E2-ADP1”
CAUTION
• Please read and ensure a proper understanding of this manual before installing, connecting (wiring), operating, or conducting
maintenance and inspection of the interface option.
• Improper handling might result in incorrect operation, a short life, or even a failure of this product as well as the motor.
• Deliver this manual to the end user of this product. The end user should store this instruction manual safely until suc time as
the product is disposed of.
(8)
Tighten with tapping screws *
1
Tightening torque: 0.25Nm *
2
*1
*2
The attachment will be temporarily secured with the clips on
the case, however, it must be secured properly with the tapping
screws before performing operation.
The tapping screws may be deformed or damaged if tightened
with more than the specified amount of torque.
Front view of screw tightening locations
(9)
Align the option card with the protrusion
(11)
Tighten the board securing screws (provided with
the option card). Tightening torque: 0.7Nm
(13)
Push the option card down
in the direction
Protrusion
(10)
(12)
(14)
(15)
Attachment
installation
complete
Part A
Use the screw (M3 x 6) provided to connect the ground wire to
Tightening torque: 0.7Nm Recommended ground wire size: AWG 20 to 16 (0.5 to 1.5mm
2
)
Part A
Note
If removing the attachment, always disconnect one side of the harness connector beforehand.
Note
Always connect the attachment ground wire to the inverter ground to ground the inverter also.
IMO Precision Controls Ltd
1000 North Circular Road, London NW2 7JP, United Kingdom
Tel: +44 (0)20 8452 6444 Email: [email protected] Web: www.imopc.com
