The information contained herein is intended for the use of the individual(s) named above and those authorized to receive it. Dissemination, distribution
or copy of this information is strictly prohibited.
ASSEMBLY INSTRUCTIONS PLEASE READ CAREFULLY
Model No.
Inside
Dimensions
Outside
Dimensions
Recommended Concrete
Pad Dimensions
1000DS Series
90"W x 174"L x 78"H
93 3/4"W x 177"L x 81 1/4"H
104"W x 188"L x 6" Thick
1000TDS Series
90"W x 174"L x 90"H
93 3/4"W x 177"L x 93 1/4"H
104"W x 188"L x 6" Thick
1.
The concrete base should be 6” thick x 14” longer than enclosure ID x 14” wider than enclosure ID.
A.
Mark the concrete base for the outside of the enclosure (3” wider than ID and 3” longer than ID).
2.
The PVC masking film will help to protect the finish of the metal panels during installation. These
coatings should be left intact and removed only after assembly of the enclosure is complete.
A.
Stand both sets of “A1” & “A2” panels firmly together. Fasten the panels together through the holes
provided on the inside of the panels using hex headed screws. Make sure the panels are pulled tightly
together before tightening the screws. (For best results, insert a bead of silicone caulk into the inside
bend of the “A1” panel flanges.)
B.
Assemble each “B-A1-A2-B” (side-end-side) assembly through the holes provided using hex headed
