Landscape Lighting
IMPORTANT: This product requires a 12V AC or DC Power
Supply and Power Cable (not included). For maximum lighting
control and efficiency, we recommend using the Hydro-Rain
®
3-Station LED Landscape Light Controller/Transformer
(06700). Power cable should be 12G-16G outdoor landscape
lighting wire.
WARNING:
• Read all instructions thoroughly before use.
• Do not install or connect electrical wires with wet hands.
• For low voltage landscape lighting systems only.
• Do not drive over electrical cables.
• Main low voltage cable (power supply cable) to be buried
less than 6 inches beneath the ground surface.
• Do not submerge product in water.
• This product for use only with a 12V power supply.
• WARNING - Risk of Electric Shock. Install all luminaires
10 feet (3.05 m) or more from a pool, spa, or fountain.
ASSEMBLY AND INSTALLATION
1. At desired installation location, loosen the ground and
insert the mounting stake. If using a hammer, place a
board on top of stake to avoid damage to the stake.
2. Clear dirt and debris away from wire slot in top of stake.
3. Assemble the pathlight by screwing the light shade
onto the stem.
4. Lay 12V wire cable from light into the stake’s wire slot
and screw stem into the stake. Do not overtighten. If light
assembly needs straightening, gently push or pull on the
stake only.
CONNECTING TO POWER SUPPLY WIRE
CAUTION: Use shielded power cable for outdoor use
in the following sizes: SPT-2W 16G, SPT-2W 14G,
SPT-2W 12G.
IMPORTANT: Turn off power before installing or removing
connector. Product to be used in accordance with local and
national codes.
1. Strip light wire ½ inch from ends.
2. Cut power supply cable and strip all wires on both sides
½ inch from ends.
3. Straighten any frayed strands.
4. Place one wire from each end of the power supply cable
together with one of the light wires with ends of insulation
even. See figure 1. (It does not matter which power supply
cable is connected to which light cable, as light cable is
not polarized.)
5. Twist connector onto wires pushing firmly until hand-tight.
Do not over torque.
6. Do not reuse connectors, as they may lose sealant.
7. Repeat steps 4-6 with the remaining 3 wires (1 wire from each
end of the power supply cable and the remaining light wire).
See figure 2.
Hydro-Rain
®
915 Overland Street
North Salt Lake, UT 84054 USA
www.hydrorain.com
1-888-493-7672
PN 06701-24 rA
Stem
Shade
Stake
Wire slot
Power Cable
Light Cable
Figure 1
Figure 2
MODELS:
HRL-BKP1-LED-3W (06701)
HRL-BRP1-LED-3W (06703)
