Chicago Approved LED Emergency Unit
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following.
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1.
Consult local building code for approved wiring and installation.
2.
Disconnect AC power before servicing and installation .
3.
Do not mount near gas or electric heaters.
4.
Do not use outdoors.
5.
Do not use this equipment for anything other than its intended use.
6.
The use of accessory equipment not recommended by the manufacturer will void product listing and warranty and may cause
an unsafe condition.
7.
Any service on this equipment should be performed by qualified personnel only.
8.
Equipment should be mounted in locations and at heights where it will not be subject to tampering by unauthorized personnel.
9.
Use caution when servicing batteries.
10.
Cap unused wires with enclosed wire nuts or other approved method.
11.
Make sure wire terminations are secure and leads are properly tucked in appropriate wire channels.
INSTALLER:
•SEE UNIT LABEL FOR ADDITIONAL MODEL SPECIFICATIONS
•SAVE THESE INSTRUCTIONS FOR USE BY OWNER/OCCUPANT
RECYCLING INFORMATION
All steel, aluminum and thermoplastic parts are recyclable.
NOTICE: Emergency units contain rechargeable batteries which
must be recycled or disposed of properly.
Hubbell Lighting, Inc. Life Safety Products • www.dual-lite.com
Copyright
©
Hubbell Lighting, Inc., All Rights Reserved • Specifications subject to change without notice. • Printed in U.S.A.
603932
16/11/16
WARNING- This product contains chemicals known to the State of Califorina to cause cancer, birth defects, and/or other
reproductive harm. Thoroughly wash hands after installing, cleaning, or otherwire touching this product.
CAUTION:
The battery in this unit may not be fully charged. After electricity is connected to unit, let battery charge for at least 24 hours, then normal
operation of this unit should take effect. To check, press the TEST button. The lamps on the unit should turn on.
