230mm
Concrete
Grinder & Dust
Extractor
Powerful portable concrete grinder
fitted with dust extraction shroud for
use with HSS dust extraction units.
Operating & Safety Guide 429
Apply just enough pressure to ensure reasonable
progress. Too much pressure will damage the disc, the
work area, and the machine’s motor.
Keep an eye on the wear rate of the disc
remembering to inspect it with the machine OFF.
The disc has diamond cutters, these will wear down
during normal use. If you use the equipment as
described the cutters should wear evenly.
When the
disc has worn out replace it with a new one,
following the instructions in GETTING STARTED.
Discs are available sale or return from your local HSS Hire
Shop.
To turn OFF the Grinder, let the trigger switch go.
Be aware of the gyroscopic effect created by the machine
once it has been switched OFF.
Hold the Grinder still
until the disc has stopped spinning.
Never push the equipment beyond its design
limits.
If it will not do what you want with reasonable
ease, assume you have the wrong tool or blade for the
job. Ask at your local HSS Hire Shop for advice.
Keep the equipment clean,
(especially the motor’s
ventilation slots). You will find this less of a chore if you
do it regularly rather than wait until the end of the hire
period. Always switch OFF and unplug the tool prior to
cleaning.
Regularly check that the disc and extractor shroud
have not become loose, if either have, STOP work
and contact your local HSS Hire Shop for advice.
When not in use, remove disc and store the
equipment somewhere clean, dry and safe
from
thieves.
Switch OFF and unplug the Grinder then remove
the disc
(simply reverse the fitting procedure explained
in GETTING STARTED).
Clean the tool up
as far as possible, paying special
attention to the motor’s ventilation slots.
Finally,
neatly coil the cable and collect all the
components ready for return to
your local HSS Hire Shop.
FINISHING OFF
EQUIPMENT CARE
Code 06333
©HSS Hire Service Group Plc 2002 No. 429/01
Group Office: 25 Willow Lane, Mitcham, Surrey CR4 4TS
Web Site: http://www.hss.com
Contact your local
0845 728 2828
…any comments?
If you have any suggestions to enable us to improve
the information within this guide please fax your
comments or write to the Product Manager at the
address below
Fax: 020 8687 5001
429/01
ON/OFF
Trigger
Lock OFF
Button
1
2
Handle
Alternative Position
for Handle
Spindle
Lock
To Dust
Extractor
Grinding Operation
Dust
Extrator
Disc
90
°
Concrete Grinder
