background image

GB

Wireless

Network Master ETH/WiFi T2

Honeywell Life Safety AS, Postboks 263, 1372 Asker

 http://www.hls-nordic.com 

Dimensional drawings:

The 

138091

  Wireless  Network  Master  ETH/WiFi  T2  is  a  master  device  (Gateway)  with 

Ethernet & Wi-Fi connectivity, for TELA2 Wireless Lighting system.

Ÿ

Wi-Fi - WPA2/PSK

Use the mounting holes to install the device to a wall surface. Avoid metallic surfaces or glass. 
Use the spirit level (bubble) for horizontal alignment.

If Ethernet connectivity is going to be used, the device must be placed close to an Ethernet 
network source (socket/switch/router). 

If Wi-Fi connectivity is going to be used, the device must be placed within range of a present 
Wi-Fi network. Use a laptop or a smartphone to ensure signal level before installing. 

Ÿ

Wi-Fi - WPS

The  device  supports  both  Dynamic  (DHCP)  and  Static  IPv4  addressing  options.  The 
communication protocol is TCP with TLS/SSL security layer. 

Ÿ

Ethernet (wired)

 

The 

138091

 must be placed in a central point of the entire Wireless Lighting installation area 

in order to achieve multiple available routes for the data transmitted (star connection). The 
wireless  network  is  “mesh”  type,  meaning  that  each  wireless  device  is  also  a  repeater.  The 
recommended  number  of  wireless  devices  directly  connected  into  the  Gateway  is  5  to  10. 
Direct connection is achieved when a wireless device is located within Gateway wireless range 
(20 to 25 meters – building interior).

Installation:

The 

138091

  must  be  supplied  with  a  permanent  220-240V  AC/50-60Hz  power  supply 

through  a  circuit  breaker  equivalent  to  the  total  load  of  the  emergency  lighting  equipment. 
The device does not implement backup power supply in mains interruption; therefore, if the 
monitoring system is required to be active during mains interruption (emergency), the device 
must be supplied via a UPS power line. 

The available connection methods to the local network are:

The 

138091

  is  capable  of  monitoring  up  to  250  wireless  devices  (consisted  of  emergency 

luminaires, extenders, I/O units, other), forming a wireless network.

80mm

19mm

120mm

104mm

34mm

Summary of Contents for Wireless Network Master ETH/WIFI T2

Page 1: ...138091 must be placed in a central point of the entire Wireless Lighting installation area in order to achieve multiple available routes for the data transmitted star connection The wireless network is mesh type meaning that each wireless device is also a repeater The recommended number of wireless devices directly connected into the Gateway is 5 to 10 Direct connection is achieved when a wireless...

Page 2: ...f the available connection methods in order to establish communication between the 138091 and the TELA2 software depending to your application Commissioning First via the TELA2 software user interface go to Installation Add Gateway and click Start The software will enter a mode to accept new Gateway devices 138091 STEP 2 Configure the Gateway to connect to local network and TELA2 Use your Wi Fi de...

Page 3: ...n the WiFi PSWD field write the WPA2 PSK password of the Wi Fi network In the IP static field write the static IPv4 address for this Gateway device or leave empty for dynamic addressing DHCP option On the TELA2 software Add Gateway window you will see a confirmation message Gateway added successfully Close the window and proceed into auto detecting or easy commissioning procedure Then select the E...

Page 4: ...1 b g n WPA2 PSK or WPS 10 100 Base T Ethernet RJ45 socket 250 192 168 1 1 WIRELESS_LIGHTING_GATEWAY WIRELESSGW 868 150 868 450MHz 11dBm 2 868 150MHz 00000001 00000000 o 5 to 40 C Power consumption IP Rating Ambient temperature range Wi Fi protocol Ethernet connectivity Ethernet port Max wireless device capacity Webpage address Wi Fi Access point SSID Wi Fi Access point password Wireless Frequency...

Reviews: