PRO
3000
Series
Non-Programmable
Digital Thermostat
Installation Instructions
Installation
Instructions
Non-Programmable
Digital
Thermostat
Wallplate installation
PULL HERE
HIPS
Remove the wallplate from the
thermostat by pulling from the bottom,
then follow directions below for
mounting.
1. Pull wires through wire hole.
2. Position wallplate on wall, level and
mark hole positions with pencil.
3. Drill holes at marked positions as
shown below, then tap in supplied
wall anchors.
4. Place wallplate over anchors, insert
and tighten mounting screws.
Drill 3/16”
holes for
drywall.
Wire hole
Mounting
screws
Drill 7/32”
holes for
plaster.
