Hünegräben 26 · 57392 Schmallenberg · Germany ·
Tel.: +49 2972 97880 · E-mail: helix@audiotec-fi scher.com
HEC BT - V EIGHT DSP
HELIX EXTENSION CARD
Bluetooth
®
INPUT MODULE FOR HELIX V EIGHT DSP
Congratulations!
Dear Customer,
congratulations on your purchase of this high-qual
ity HELIX
EXTENSION CARD. This module is produced by using the latest
technology. We wish you many hours of enjoyment with your new
HELIX product.
Yours,
AUDIOTEC FISCHER
General installation instructions for HELIX components
To prevent damage to the unit / module and possible injury, read this
manual carefully and follow all installation instructions. This product
has been checked for proper function prior to shipping and is guaran-
teed against manufacturing defects.
Before starting your installation, disconnect the battery’s nega-
tive terminal and all cables from the device to prevent damage
to the unit / module, fi re and / or risk of injury.
For a proper perfor-
mance and to ensure full warranty coverage, we strongly recommend
to get this product installed by an authorized HELIX dealer.
Install the HEC module only in the designated device and its
specifi c slot. Using the HEC module in other devices or slots
can result in damage of the HEC module, the amplifi er, the head
unit / radio or other connected devices!
Technical data
Bluetooth
®
standard:
v3.0 + EDR
Bluetooth
®
profi le:
A2DP
Bluetooth
®
codec:
SBC and Qualcomm
®
aptX
®
Number of paired devices:
8
Wireless frequency range:
2402 ~ 2480 Mhz
Range:
Up to 10 m
Digital optical output:
SPDIF with 48 kHz / 24 Bit
Mounting information
1. First disconnect all cables from the device.
2. Dismantle the side panel by removing the marked screws with a
Phillips screwdriver and an allen key:
3. Pull out the bottom plate.
4. Remove the nut and the washer from the antenna socket of the
HEC module.
5. Insert the HEC module into the marked slot:
6. Make sure that the HEC module is installed properly and all pins
are fully inserted into the socket:
7.
Reinsert the bottom plate and fi x the new side panel which is
delivered with the HEC module with the Phillips and allen screws.
8. Put the washer and the nut on the antenna socket and bolt it to
the side panel.
Caution:
Do not overtighten the nut as this may damage the
socket!
9. Reconnect all cables to the device.
