![background image](http://html1.mh-extra.com/html/heirloom/artos-wall-series/artos-wall-series_installation_2120046001.webp)
Artos Wall NZAust v1.3
ARTOS WALL SERIES TOWEL WARMER
The Advanced Art of Towel Warming
Operation
Your ARTOS Towel Warmer uses only minimal electrical power - about the same as an average light bulb. It will take
approximately 20-30 minutes to reach maximum operating temperature. For best results, only two - three generous
sized towels should be heated at one time. The heat of this unit may increase significantly if overloaded with an
excessive number of towels. NOTE: The temperature of your towel warmer will vary with the ambient temperature of
your room. As a result of this the warmer will feel hotter to touch during warmer periods. A towel warmer is designed
to warm and assist the drying of towels and will normally operate at a temperature that is too hot for the warmer to be
grasped for an extended time
Locating Instructions
Detailed installation instructions are provided on the reverse side. The ARTOS Towel Warmer should be fixed through
the wall cladding directly to studs or other suitable anchor material. It should be at least 55mm below the ceiling or any
overhanging surface and at least 300mm above the floor or 40mm above counter top and should not in any
circumstances be located in the direct path of a water source (tap or shower etc)
Electrical Installation
Please ensure your towel warmer is installed by a registered electrician and ensure the electrical supply, plug & switch
location, and product location will comply with your local regulations.
New Zealand electrical wiring requirements stipulate that this appliance must be wired by a registered electrician in
accordance with current electrical wiring regulations. This appliance must be fitted with an air gap phase isolation
switch which isolates the phase & neutral in accordance with local wiring regulations.
This product must be used in
conjunction with a hard wired switch
.
For greater temperature control a wall mounted dimmer switch (with “off”
position) is recommended.
Care and Cleaning
All components are made from high quality materials. The finish of your Towel Warmer is hard wearing and easily
maintained. Clean with a soft cloth and non-abrasive cleaning agent as required to keep the warmer in good condition.
Warranty
This product is warranted against defects due to faulty workmanship or materials for 10 years from date of purchase.
In the event of a defect in the product, turn it off at the wall, and contact the retailer from which it was purchased and
provide details from your sales receipt and the products serial number from the label on the towel warmer. The retailer
will contact Heirloom who will assess the matter and if accepted as a valid warranty claim the product will be repaired
or replaced at Heirloom’s option – free of charge. Costs of disconnection, reconnection, and freight are the
responsibility of the owner, as is any damage arising in transit to and from servicing by Heirloom. This warranty does
not cover:
a.
Any damage to the product caused by misuse, neglect, accident, or in violation of the manufacturer’s
instructions, or
b.
Any damage, loss or injury arising as a consequence of the use of the product.
Australia: Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and
the failure does not amount to a major failure.
Heirloom International Limited, P O Box 204 235, Auckland 2161, New Zealand.
Ph +64 9 274 4443 [email protected]
Contact Us
We welcome your feedback on our products. You can view our full range of towel warmers on our website and send us
your comments about this product using the Contact Us page on our website www.heirloom.co.nz