1. INTRODUCTION
Heatit ZM Single Relay is a high power relay for inwall installations.
The relay allows you to control connected devices either through your
Z-Wave network or via a wired switch. The module is equipped with a
16A relay and has a scene controller functionality.
The device can withstand a load of max 16A /3600W at 230VAC.
2. STATEMENT REGARDING PRODUCTS FROM MULTIPLE
MANUFACTURERS
Please read this before installation
This device may be used with all devices certified with the Z-Wave
Plus™ certificate and should be compatible with such devices
produced by any manufacturer. Every primary controller is different
depending on the manufacturer, their target audience and intended
use/application. Please review the functionalities implemented by the
primary controller you intend to use with our Z-Wave Plus certified
device to ensure that it provides the necessary controls to take full
advantage of our product’s capabilities.
3. BEHAVIOR WITHIN THE Z-WAVE™ NETWORK
This device may be operated within any Z-Wave network with
Z-Wave-certified devices from other manufacturers. All non-battery-
operated nodes within the network will act as repeaters regardless of
manufacturer to increase the reliability of the network. On delivery, the
device does not belong to any Z-Wave network.
The device needs to be added to an existing network to communicate
with the other devices within it. Devices may also be removed from
a network. The add/remove processes are initiated by the primary
controller of the Z-Wave network.
4. QUICK START
1. Switch off the mains supply (disable the fuse).
2. Open the wall switch box.
3. Connect wires according to the labeling described in Chapter 5
”Installation”.
4. After verifying the connections, switch the mains supply back on.
5. Set the primary controller in add mode (security/non-security).
6. Press the configuration button or switch connected to S1 x 3 times in
rapid succession.
7. The device LED will blink in green when adding procedure has been
successfully initiated. When the device is included in the home
automation system, the LED will light up in green for 1 second.
If the device is unsuccessfully added, the LED will light up in RED for
1 second. For more information, please see Chapter 7 ”Add/ Remove”.
8. Change the value of Parameter 11 to 10% of your connected load.
TABLE OF CONTENTS
1
Introduction
2
Statement regarding products from multiple manufacturers
3
Behaviour within the Z-Wave™ network
4
Quick Start
5
Installation
6
Control
7
Add/Remove
7.1
Method 1: Standard (Manual)
7.2
Method 2: SmartStart (Automatic)
8
Factory Reset
9
Startup
10
Safety Features
10.1
Overload
10.2
Overheating
11
Switch Mode
11.1
Momentary Switch (NO) - Default
11.2
Toggle Switch (ON/OFF)
12
LED Blinking patterns description
13
QR-Code placement (DSK)
14
Security
15
Node Information Frame
16
Associations
16.1
Setting and removing associations
16.2
Association Groups
17
Configuration Parameters
18
Command Classes
18.1
Basic Command Class
18.2
Binary Switch Command Class
18.3
Central Scene Command Class
18.4
Meter Command Class
18.5
Notification Command Class
18.6
Indicator Command Class
19
Supported Command Classes
20
Technical documentation
HEATIT
ZM SINGLE
RELAY 16A
Ver 2020-B
Firmware 1.0
01.12.2020
Installers manual
