![background image](http://html1.mh-extra.com/html/hearth-and-home/wsk-soul-tmr/wsk-soul-tmr_installation-and-operating-instructions_2114415001.webp)
2081-935 Rev D 12/19/05
Page 1 of 5
WSK-SOUL-TMR
INSTALLATION AND OPERATING INSTRUCTIONS
INTRODUCTION
Hearth & Home Technologies wireless wall mount timer system was developed to provide safe, reliable, and user-friendly remote
control system for gas heating appliances. The system can be operated manually from the transmitter. The system operates on one of
65,536 security codes that are programmed into the transmitter at the factory.
COMPONENTS
WALL TIMER
The wall timer operates on a (2) 3V button cell batteries (included) made
specifically for remote controls and electronic lighters. Before using the wall
transmitter, install the two (2) 3V button cell batteries. Follow instructions below.
The wall timer has a 30 min, 60 min, 120 min, and OFF buttons. When any of the
buttons on the wall timer is pressed, a signal light on the wall timer illuminates
briefly to verify that a signal has been sent. If the signal light does not illuminate,
check the batteries. Upon initial use, there may be a delay of five seconds before
the remote receiver will respond to the wall timer.
Note:
In addition to these instructions read and
follow instructions in gas appliance Owner’s Guide.
WARNING
!
Hearth & Home Technologies disclaims any responsibility for,
and the warranty will be voided by, the following actions.
•
Installation and use of any damaged system
component.
•
Modification of the system component.
•
Installation other than as instructed by Hearth &
Home Technologies.
•
Installation and/or use of any component part not
approved by Hearth & Home Technologies.
Any such action may cause a fire hazard.
Read, understand and follow these instructions for safety and
operation.
TRANSMITTER
REMOTE RECEIVER
SLIDE
BUTTONS
R
E
M
O
T
E
ON
OFF
WALL-MOUNT COVERPLATE
AA BATTERIES
2 ea.
12V (A23) Transmitter
battery(included in
transmitter)
4 ea.
HARDWARE
(2) 3V Button Cell Transmitter
batteries (included in
transmitter)
3V
3V
2 ea.
Indicator
Light
30 MIN
60 MIN
120 MIN
OFF
REMOTE
OFF
ON
LEARN
ADJ.
Indicator
Light
30 MIN
60 MIN
120 MIN
OFF