1
3-89-797022_R2 • 10/17
Oakleaf Combustion Package Replacement Instructions
Part # 1-00-797022
Figure 1
Upper Brick
Clip
Figure 3
Center
Brick
Figure 2
Rear Brick
Clip
Andirons
4. Remove (2) 1/4”-20 x 3” cap screws and remove the
shoe brick. Figure 4.
Figure 4
1/4”-20 x 3”
Cap Screws
Figure 5
Center
Seal Plate
2. Remove the (2) andirons along with (2) rear brick clips
located at the top corners of the center brick. Figure 2.
3. Remove the decorative center brick. Figure 3.
5. Remove (2) 1/4”-20 x 1/2” bolts and remove the center
seal plate. Figure 5.
Contents of Kit;
(1) 3-40-797022 - Combustion Package with Gasket
(1) 2-00-797504 - Combustion Package Cap
(2) 3-30-1252005014 - 1/4-20 x 1/2” HCS
(2) 3-30-1311820013 - 5/16-18 x 2” HCS
(2) 3-30-3025202509 - 1/4-20 x 2-1/2” SS SHCS
(2) 3-30-80311813 - 5/16-18 FHN
(2’) 3-44-10050 - 1-1/2” x 3/8” Bulb Gasket w/PSA
(10’) 3-44-1312 - 1/4” Round Gasket w/PSA
The following are instruction on how to properly replace
the
Oakleaf
combustion package.
Note:
The combustion
package must be removed from the front of the unit.
1. Remove (2) front upper brick clips located at each front
corner of the firebox and remove side bricks. Figure 1.
