Introduction
Thank you for purchasing Gerbing’s Li-ion Battery models
B7V-2500 battery. Please read the entire user manual prior
to use.
Gerbing’s Li-ion Battery is a slim and lightweight external
battery pack that will allow you to power a variety of our heated products.
Features
•
Ultra-lightweight construction reduces bulk and weight
•
LED battery level indicators
•
LED power setting indicators
•
Battery provides 2,500 mah of power
NOTE:
Failure to charge battery prior to use will reduce battery life.
CHARGE BATTERY REGULARLY
It is important to maintain at least 25% of your battery power when
not in use. Failure to do this will result in performance problems and
reduced battery life.
Be certain to use your battery with products with an amp rating less
than the maximum capacity output rating for the battery. For
instance, the Li-ion battery pack has a maximum capacity output
rating of 2 amps and should not be used with heated products that
draw more than 2 amps. Please check your products amp draw before
connecting battery pack. Failure to do so can overheat the battery
causing damage.
Disposal
Do not place in fire or incinerate
Do not dispose in refuse
Recycle in accordance with local regulations
www.gerbing.com
Safety Precautions
Please read the following warnings carefully before using the B7V-5200
Li-ion battery. Use the
product correctly and according to
the procedures described in this manual.
WARNINGS
• Do not attempt to disassemble or alter any part of this product.
• Do not store below -4° F (-20° C) or above 140° F (60° C).
• Do not allow this product to have contact with water or other liquids.
If water or other liquids enter the battery interior, immediately
unplug the product from the battery. Continued use of the product
may result in fire or an electrical shock.
• Do not place this product near a heat source or expose the battery to
direct flame or heat, as the battery may explode.
Prior to Use
Please read the following warnings carefully before using the BATLI722 (R)
or B7V-2500 Li-ion battery. Use the product correctly and according to
the procedures described in this manual.
Charging the B7V-2500 battery
Please refer to Figure 1 to become familiar with all aspects of the B7V-2500
To set up the charging process, proceed as follows:
1. Locate the chargers case with the 110v input prongs.
2. Plug the charger into a properly rated AC outlet (110v).
3. Plug the charger output cable(s) into the batteries charging ports.
4. The battery power level indicator LED is green when it’s fully charged or
red if charging is needed.
5. Charge battery until the red LED on the charger is a green color and all
four LED’s on the battery are illuminated. The battery is now fully charged.
