JUMBO
DISPLAY
DIGITAL
TIMER
USER’S MANUAL
TI899B
Please read this manual carefully and thoroughly before using this product.
SETUP INSTRUCTIONS
1.
Remove the plastic film from the display.
2.
In the back of the unit, open the battery
compartment by sliding its cover up and off in the
direction of the arrow (see figure).
3.
Insert the supplied “AAA” battery in the direction
indicated. The beeper will sound quickly four times.
The display will show a running clock beginning at
AM 12:00:00
.
4.
Replace the battery compartment cover.
TO SET THE CLOCK
1.
Press and hold the
CLOCK
button. A black cursor will
blink in the bottom left corner of the display.
2.
Press the sequence of number keys corresponding
to the present time, adding an initial
0
for single-
digit hour numbers. For example: To set the clock to
4:15 (AM or PM), press
0 4 1 5
. To set the clock to
11:30, press
1 1 3 0
. If you make a mistake entering
digits, press the
CLEAR
button. This resets the
procedure to the first step.
3.
Toggle between
AM
and
PM
(shown at the left of the
time) by pressing the
START/STOP
button (stenciled
AM
≈
PM
in black).
4.
When the hours and minutes digits (and AM or PM
setting) of the time are correct as shown, add the
seconds digits by pressing any two number buttons
(or
0 0
at the top of the minute for a precise setting).
This saves the clock setting.
5.
To view the clock display in 24-hour (military)
format, press the small gray button on the upper
back of the unit stenciled
12 HR
≈
24
HR in black.
Magnet
TI899B Manual FINAL-102711_awb 10/27/11 3:53 PM Page 1
