Garmin Vector, Quick Start Manual

Page: 1 / 25

1
Getting Started

WarninG
Read all instructions carefully before installing and using the Vector
™
system.
Improper use could result in serious injury.
See the Important Safety and Product Information guide in the product box for
product warnings and other important information.
notice
Go to www.garmin.com/vectorowner for the latest information including bike
compatibility, software updates, and video tutorials.
Tools needed
• 15 mm pedal wrench
• Bike grease
• 3 mm and 4 mm hex keys
installing Vector Components
Preparing the Crank arms
1 Remove the existing pedals.
2
Clean the threads and remove old grease.
Determining Pedal Pod Clearance
notice
The pedal pod should contact the crank arm only at its mounting face, because
this is the load-bearing connection. If the pedal pod contacts the crank arm
anywhere else, the pedal pod may fracture when the pedal is tightened.
• If the mounting face
➊
surrounding the threaded hole in the crank arm is
recessed, use one or more washers
➋
to fill the recess.
• Make sure the pedal pod mounting face
➌
contacts the crank arm only at its
mounting face (or the washer used to fill the recess).
If the pedal pod touches the crank arm anywhere else, use another washer
to provide the necessary clearance.
• If the mounting face of the crank arm is protruding, do not use washers.
Determining the Bicycle Chain Clearance
Before you can install the right pedal, you must confirm bicycle chain clearance.
Move your bike chain to the largest crank gear and the smallest cassette
gear.
The bike chain should be in the outermost position to determine proper
clearance between the pedal pod cable and the chain.
nOTE : There should be at least 5 mm clearance
➍
between the chain and
the crank arm.
➍
installing the Pedal Pod and Pedal
nOTE : The left and right pedal pods are the same.
1
Install the left pedal first.
2
Apply a thin layer of grease on the pedal spindle
➎
and the pedal pod
➏
where it contacts the pedal spindle.
➎
➑
➐
➒
➏
3
On the pedal spindle, stack the pedal pod and any required washers
➐
.
nOTE : You must carefully bend the cable
➑
out of the way.
4
Insert the spindle into the crank arm
➒
.
5 Hand tighten the spindle.
nOTE : The left pedal tightens counter clockwise. The right pedal tightens
clockwise.
TiP : Power and cadence calculations are not impacted by the orientation
of the pedal pod. Garmin recommends placement of the pedal pod on the
leading edge of the crank. When the crank is in the forward position, the
pedal pod should be pointing downward.
Quick Start Manual ................................................................... 1
Manuel de démarrage rapide ................................................... 3
Manuale di avvio rapido ........................................................... 5
Schnellstartanleitung ............................................................... 7
Guía de inicio rápido ................................................................ 9
Manual de início rápido ......................................................... 11
Snelstartgids ........................................................................... 13
Lynstartvejledning .................................................................. 15
aloitusopas ............................................................................. 17
Hurtigstartveiledning ............................................................. 19
Snabbstartshandbok .............................................................. 21
Skrócony podręcznik użytkownika ....................................... 23