
WARNING
Ta k e t h e s a m e p ro t e c t i v e m e a s u r e s
against vibration, shock, high temperature,
and the invasion of moisture with the SBE-1 as
you do with the receiver.
s0RECISION PAR TS ARE USED IN THE 3"% )N
ADDITION IT IS NOT CONSTRUCTED TO PREVENT THE
INVASION OF MOISTURE4HERE IS THE DANGER OF A
CRASHDUETOABNORMALOPERATION

CAUTION
Do not connect anything other than an
S-BUS device to the S.BUS output.
s4HERE IS THE DANGER OF ABNORMAL OPERATION AND
DAMAGE
S.BUS ENCODER
Instruction Manual
That you for purchasing an
SBE-1
S.BUS
*1
encoder.
The
SBE-1
is a converter that is used when using a
CGY750 gyro or other exclusive S-BUS receiver device
with a receiver for conventional system use.
The signals (PWM) of a conventional system of up to 10chs
can be converted to S.BUS system signals.
*1
S.BUS: Standard name of Futaba serial communication for R/C
systems.
[SBE-1 ratings]
07-
Æ
3"53#ONVERTER
s07-INPUT-AXCHS
s)NPUTPULSEWIDTH^
μ
3
s)NPUTFRAMERATE^M3
s/UTPUTSIGNAL3"53
s3"53DATARATEKBPS
s/UTPUTFRAMERATE!PPROXM3
s/PERATING VOLTAGE RANGERATED
^6
s$IMENSIONS XXMM
EXCLUDINGCABLE
s7EIGHTGINCLUDINGCABLE
s/PERATING TEMPERATURE RANGE
^ #
s3 T O RA G E T E M P E RA T U R E RA N G E
^ #
s07-INPUTCONNECTOR
* Connects all the connectors corresponding to the
channel necessary to operate the S.BUS device.
* Always connect the CH1 and CH2 connectors.
(To supply power to the SBE-1 and S-BUS device)
s3"53OUTPUTCONNECTOR
* C o n n e c t s t o t h e S . B U S i n p u t
connector of an S.BUS device.
Precautions
Name of Each Part and Connection Method
To conventional
system receiver
(up to 10chs)
To S-BUS device
07-
Æ
S.BUS Converter
Futaba Corp. will not be responsible for
damages, etc. caused by combination with
other than Futaba Corp. products.
3
5
7
1
2
3
4
5
6
7
8
9
10
SBE-1
LED (green)
-.
FUTABA CORPORATION Phone: +81 475 32 6982, Facsimile: +81 475 32 6983
1080 Yabutsuka, Chosei-mura, Chosei-gun, Chiba 299-4395, Japan
©FUTABA CORPORATION 2011, 7 (1)
Note: Always read this manual before using the SBE-1.
Store this manual where it can be used at any time.
[Accessories]
s/UTPUT#ONNECTOR!DAPTER
*Use this adapter to connect the output connector
to an S.BUS Hub with Cable, etc..
s,%$DISPLAY
3TATE
$ISPLAY
No signal
Blinking
PWM input
Steady light
* Lights when a regular signal is
received on any channel.
