Nano UPS Quick Guide
V.1.0
Package Contents
You should have received the following items inside of package:
UPS Unit
Quick Guide
-Power cable (only for the IEC-type model)
-
-
1
4
Installation & Initial Startup
NOTE:
Placement & Storage Conditions
Connect to Utility and Charging
Before installation, please inspect the unit. Be sure that
nothing inside the package is damaged.
Install the UPS in a protected area that is free of excessive dust and has adequate
air flow. Please place the UPS away from other units at least 20 cm to avoid
interference. Do NOT operate the UPS where the temperature and humidity is
outside the specific limits. (Please check the specs for the limitations.)
Before initial use, please p
lug in the AC input cord to the
wall outlet and turn on the UPS for charging. For the best
results, suggest to charge the battery at least 8 hours
before initial use. The UPS charges its battery while
connecting to the utility with power on.
Plug in the loads to output receptacles on the rear panel of the UPS. Simply
turn on the power switch of UPS unit, then devices connected to the UPS will
be protected by UPS unit.
connect a laser printer or scanner to
the UPS unit. This may cause the damage of the unit.
Connect the Loads
CAUTION: NEVER
Turn On/Off the Unit
Indicators & Alarm Table for Operation
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit by
pressing again the power switch.
2
Front View:
Back View:
AC input
Output receptacles
Circuit breaker
Power switch
UPS status indicator
Fault/Battery status indicator
(Check the Indicator & Alarm Table for the details)
1
2
3
IEC Type
1
2
3
NEMA Type Universal Type Schuko Type
Product Overview
3
Product Introduction
1
2
3
The Nano UPS provides comprehensive protection in a small and economic package.
The UPS is more compact and offers greater comprehensive power protection against
surges and spikes. This UPS will continue providing stable power to connected
equipment and enable to shutdown PC safely during power failure. Its embedded
microprocessor controller guarantees high reliability and it’s perfect for any home
or small office application.
1
2
3
2
3
1
8 hours
20cm
20cm
Conditions Visual Indications Alarm
Off
Green LED lighting
Green LED flashing
every 10 seconds
Green LED flashing every
second & Red LED lighting
Sounding every 10 seconds
Sounding every second
AC mode
Battery mode
Low battery at
battery mode
Fault Red LED lighting Continuously sounding
Alarm for over-
temperature
protection
Red LED flashing every 0.5
seconds
Off
