OMNI Tx-4.2
DCC
Programmable 2.4GHz Transmitter
For electric models with DCC
decoders and ESC, with Inertia
Or analogue DC models with up to 12 functions
P.O.Box 675
Blackburn, Lancs.
BB1 9DL
UK
Rx
-
24 receiver circuit diagram for use with a DCC Interface module.
You no longer need that big transmitter anymore! The programmable
OMNI Tx
-
4.2
handheld transmitter will control your garden railway electric locomotives perfectly
from the palm of your hand. An
Omni Rx
-
4
receiver with be needed to work with the
OMNI Tx
-
4.2
transmitter in DCC mode, but the Tx4.2 will also operate our standard
r/c Rx2 receivers installed in analogue DC models.
2.4GHz gives perfect glitch free control for up to 800 metres range with no
obstructions.
The Regulator Knob controls speed and direction is controlled be the Reverser
switch. Cruise control is possible by turning off the transmitter while the train is run-
ning. Turn back on to instantly regain control.
OMNI Tx-4.2
DCC
2.4GHz Handheld Transmitter
Regulator
Knob
Turn fully ANTICLOCK-
WISE for OFF and fully
CLOCKWISE
for
full
power.. The further you
turn, the faster the loco
goes. Perfect smooth
control to the exact posi-
tion shown on the regula-
tor dial. This knob is also
used when reprogram-
ming the top buttons.
2 x AAA
Battery box lid
FUNCTION Buttons 1.2.3 /
4.5.6 /
7.8.9 /
10.11.12
Buttons 1.2.and 3. Operate functions 1
-
12 in conjunction with the two shift buttons.
These buttons are also used to re
-
program a receiver.
Functions
4,5
,and
6
are operated by holding the
green
shift button
first,
buttons
7,8
and
9
by holding the
red
shift button
first
and functions
10,11
and
12
by holding
down
both
shift buttons before pressing the function button required.
ON/OFF
Slide Switch
Slide down for ON
If Alkaline batteries are used up to 100 hours of continuous
use is possible
InertiaKnob
Use it to match the
DCC sounds for
super smooth accel-
eration and deceler-
ation. Turn to Zero
to switch off as
shown
Full travel Regulator Knob plus Reverser switch
Inertia control for super smooth acceleration and braking
Plus
12 function
buttons for
DCC
or DC operation
2.4GHz Blue Tooth Technology by Timpdon Electronics
User programmable.
Requires an
OMNI Rx4 or Rx24
receiver with DCC interface module or
OMNI Rx2 with optional MCS switchers
Shift Buttons
Green
and
Red
Enable F4 to F12 in combi-
nation with black buttons.
Reverser Switch
Select forward, OFF or
reverse
LED’s 1 & 2
Indication of battery
and radio status plus
indications
during
bind and calibration.
