Issue Date: 10-02-98 Rev. Date: 11-03-08 Rev. Level: 09 ECN:N/A OIPM P/N 3420308 Page 1 of 4
REQUIRED CLEARANCE
Caution - Spacing:
Heaters must be mounted a minimum
of 24" from a vertical surface, a minimum of 24" from the
ceiling, a minimum of 24" from direct radiation to
combustibles, and a minimum of 2.4M (7.87’) above the
floor. Heaters must be at least 36” apart.
WARNING!
DO NOT ATTEMPT TO INSTALL, OPERATE, OR SERVICE THIS PRODUCT BEFORE READING ALL
INSTRUCTIONS CAREFULLY. FAILURE TO COMPLY WITH THESE INSTRUCTIONS COULD RESULT IN
FIRE
,
PERSONAL
INJURY
AND/OR
PROPERTY DAMAGE!
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE
.
The Mitey Midget heater is available in five lengths, ranging
from 13 inches to 46 inches. Select from a wide variety of
wattage’s and voltages, from 500W/120V to 3800W/577V.
These models have a heavy duty aluminum extrusion with
a bright aluminum insert, an aluminum housing, mounting
brackets for permanent installation or chain suspension,
and an end-to-end wireway for single end wiring and easy
installation.
All models are UL and C-UL (USA and Canada) Listed
under file #E32304, for indoor commercial and industrial
comfort heat applications.
Not for indoor residential use.
DESCRIPTION
MODEL
NUMBER
WIDTH
LENGTH
(in.)
WATTS
VOLTS
MM-13A
MM-18A
MM-18A
MM-24A
MM-24A
MM-24A
MM-33A
MM-33A
MM-46A
MM-46A
MM-46A
3-3/4”
13
18
18
24
24
24
33
33
46
46
46
500
1000
1000
1600
1600
1600
2500
2500
3000
3800
3650
120
208
240
208
240
277
480
577
480
577
480
SPECIFICATIONS
Read all instructions before using this heater.
1.
Make certain that the power source conforms to the
electrical requirements of the heater. Disconnect power
before installing or servicing. If the power disconnect is out
of sight, lock it in the open position and tag it to prevent
unexpected application of power. Failure to do so could
result in fatal electric shock.
WARNING: DO NOT DEPEND UPON A THERMOSTAT OR
OTHER
SWITCH
AS
THE
SOLE
MEANS
OF
DISCONNECTING
POWER
WHEN
INSTALLING
OR
SERVICING THE HEATER. ALWAYS DISCONNECT THE
POWER AT THE MAIN CIRCUIT BREAKER AS DESCRIBED
ABOVE. FAILURE TO DO SO COULD RESULT IN FATAL
ELECTRIC SHOCK.
2.
This heater is intended ONLY for permanent installation in
accordance with the National Electric Code (NEC), all
applicable local codes and ordinances, and all sections of
this manual. Any variance voids the warranty and may
create unsafe conditions. All wiring should be done by a
qualified electrician, using copper wire only.
3.
This heater is intended for general heating applications
ONLY. It must NOT be used in potentially dangerous
locations such as flammable, explosive, chemical-laden or
wet atmospheres.
IMPORTANT SAFETY INFORMATION
4.
Special attention must be given to any bonding (grounding)
information pertaining to this heater. To prevent the risk of
electrocution, the heater must be securely and adequately
bonded. This should be accomplished by connecting a
conductor between the service panel and the green ground
screw provided in the heater. To ensure a proper bond, the
bonding means must be tested by a qualified electrician.
5.
Do not insert fingers or foreign objects into the heater. Do not
block or tamper with the heater while it is in operation. Do not
touch heater while it is in operation or just after it has been
turned off, as some parts may be hot enough to cause injury.
6.
Do not attach ductwork to this heater or attempt to use it as a
make-up air heater. Such use voids the warranty and may
create unsafe conditions.
7.
In cases where property damage may result from malfunction
of the heater, a back-up system or a temperature alarm
should be used.
CAUTION:
Check branch voltage. Heaters should be operated at
voltages no higher than the heating elements and the heater are
designed for. (Lower voltages, however, pose no problem other
than a loss of wattage).
ELECTRIC INFRARED HEATER
MITEY MIDGET
MODEL & PART NO.:
MM-13A
(04440102)
MM-18A
(04427602)
MM-24A
(04495402)
MM-33A
(04427202)
MM-46A
(04420302)
OPERATION
OPERATION
OPERATION
OPERATION –
–
–
– INSTALLATION
INSTALLATION
INSTALLATION
INSTALLATION –
–
–
– PARTS MANUAL
PARTS MANUAL
PARTS MANUAL
PARTS MANUAL
If you have questions about the
product you have purchased or would
like to leave us feedback please
contact us via our website
www.fostoriaindustries.com
or by calling 1-800-495-4525.
