MIMO2+, Multiple Input – Multiple Output
Module User Manual
1080 Centre Rd. Ste C
Auburn Hills, MI 48326
Phone: (248) 481-7092
Made in USA
072916
INTRODUCTION
The MIMO2+ (Multiple Input - Multiple Output) Module is an interface / bridge module that has two voltage inputs and two dry contact relays.
The MIMO2+ is a Security Enabled Z-Wave
TM
Plus Wireless device compatible with other Z-Wave
TM
certified products.
SPECIFICATIONS
Power:
12 to 16 volts DC from regulated Power supply @~ 500mA
capability
Frequency Range:
908.4MHz (US); 868.4MHz (EU)
Distance Range:
Max 100ft line of sight in unobstructed environment
PCB Size (LxW):
3.55" (90.2mm) x 3.3" (84mm)
Enclosure Size (LxWxD):
3.8" (96.5mm) x 3.8" (96.5mm) x 1.15" (29.3mm)
Weight:
6 OZ (170 gram)
Operating Temperature:
-10⁰C (14F) to +70⁰C (158F)
Input Signals 1, 2 (SIG1 & SIG2): Digital or Analog Input 0 to 16V DC. The trigger levels and
hysteresis can be set independently via the Configuration
Command Class for each input.
Input Signal Impedance:
Z=66 ohm at 10KHz (for SIG1 or SIG2). This impedance is =
66 ohm = 34 ohm + j 540uH.
Output Relays 1, 2 (REL1 & REL2): SPDT, Max. Switching power of 120W; 10uA to 10A; High Dielectric strength coil-contacts: 1,000 VAC; Open
contacts: 750 VAC; Conforms to FCC Part 68 requirements; Ag + Au clad bifurcated contacts fully sealed.
System Requirement:
Any Z-Wave
TM
-enabled network and controller.
WARNINGS AND PRECAUTIONS
The dry contact relays are not capable of supporting higher-than-specified loads.
Exceeding the specified switching power will cause
damage to the unit and may cause damage to property and/or personal injury, including loss-of-life.
o
WARNING – Do not attempt to use the relays to switch residential or industrial Alternating Current (AC) lines.
The relays are to be used for low-power load control only. Refer to above electrical specifications for relays.
Do not store highly flammable items such as oily rags or other combustibles near your MIMO2+.
Do not apply electrical power to the unit unless the unit is fully assembled.
Install unit in accordance with electrical codes and regulations. In case you are unsure about any parts of these instructions consult an
electrician or Z-Wave
TM
home automation specialist.
Disconnect power source before working on or servicing the unit. Failure to do so could result in personal injury.
Eye protection should be worn while installing or servicing the system. Failure to do so could result in personal injury.
MIMO2+ functionality is based on wireless (RF) transmissions. Any wireless transmission can be subject to RF interference or loss-of-
communication. This interference or loss-of-communication may cause the unit to not operate as intended. You, the end-user, are
responsible for ensuring that the MIMO2+ functionality and installation meets your desired requirements.
o
WARNING - The MIMO2+ must not be used in life support and / or safety applications.
Do not place MIMO2+ on or near metal objects. This decreases range and/or blocks wireless transmissions.
Information provided in this manual is for your convenience and may be superseded by updates. The specifications and this manual are
subject to change without notice. It is your responsibility to ensure that the MIMO2+ functionality meets your needs and specifications.
