7
8
Determine the cord length by pulling the cord. Pull at
the end to reduce the drop height, pull at the loop to
increase the drop height. Screw the half cord connector
tight to position the cord drop height (with CCS
®
:
the second cord connector in the double construction).
If necessary, cut the cord by heating it and make a knot
at the end of the cord. Tight this on the extension in
the middle of the master carrier overlap. This creates
a strong construction.
5
6
By pulling the cord through the big gap of the pulley,
it will hang straight down the curtain and a good
operation is guaranteed.
Ensure that the cord runs behind the metal pin in
the pulley. This avoids slack in the mechanism during
operation.
CKS
®
& CCS
®
Assemblage
Tips & Suggestions:
• The maximum length for cording / chaining CCS
®
is as follow:
6,10 mtr (20 Ft.) and for CKS
®
is 6 mtr (19.7 Ft.).
• The above sizes are without the pulleys! With pulleys, the sizes are as follow:
centredraw
one-way draw
CCS
®
6,18 mtr (20.27’)
6,17 mtr (20.24’)
CKS
®
6,08 mtr (20’)
6,08 mtr. (20’)
Fix one cord connector onto the end of the cord
(CCS
®
facing outside, CKS
®
to the middle of the track).
Slide the half cord connector on the other end of the
cord (with CCS
®
, use a normal CCS cord connector),
but do not screw it.
Slide the master carrier, together with the two cord
connectors into the cord channel of the track.
The cord is lifting out of the track, through the first
gap of the master carrier overlap.
Fix the second cord connector on the opposite cord,
(CCS
®
facing outside, CKS
®
towards the middle of the
track).
Slide the master carrier underlap, together with the cord
connector into the cord channel of the track and fix the
second pulley onto the track.
1
3
4
CCS
®
& CKS
®
Assembly – cord adjustability.
Instructions for assembling CCS
®
& CKS
®
, with cord adjustability.
This application can be made for CCS
®
, as well for CKS
®
. The advantage is that the requested drop height can be deter-
mined at a later stage. This feature makes the system very suitable for pre-assembling. This application is also possible
for one-way draw. Start, repeating the first two steps of the instructions with cord and continue with the steps below.
Necessary items:
Articlenumber:
CCS-track
30010.. ……
Nylon cord
1030401000
CCS Master Carrier Overlap R/L
30157…000
CCS Master Carrier Underlap R/L
30156…000
CCS End Pulley
30301…000
CCS End Pulley Small
30302…000
CKS Cord Connector
3030301000
Drill with bit 1
Lighter (for heathen the nylon cord)
Necessary items:
Articlenumber:
CKS-track
1501001…..
Nylon cord
1030401000
CKS Master Carrier Overlap R/L
1515701000
CKS Master Carrier Underlap R/L
1515601000
CKS Pulley
1530101000
CKS Cord Connector
1530301000
CKS Cord Connector (half)
1530311000
Drill with bit 1
Lighter (for heathen the nylon cord)
2
03-2006
assemblageCKSCCSEng_210306 21-03-2006 13:47 Page 4
