Installing Flexco
®
BR10 Fasteners with the
Flexco
®
Electric Powered Rivet Driver
and the Standard MBRTA Installation Tool
Warning:
Follow all maintenance and safety precautions that
are noted in the Hitachi H455R manual included in this kit.
We recommend a trial drive prior to production installation. Use of this driv-
er will vary with the length of the rivet and the type of belt you are using.
A: Aligning Bar
B: Clamp Bars
C: Cam Rods
D: Channel Base
Handle
E: Guide Blocks
F: Anvil Plates
G: SR759
H: SR-50
1. For belts with a top cover of 3/16” (4.8
mm) or more, skiving is recommended.
Refer to FSK
™
Belt Skiver instructions.
2. Remove aligning bar (A), clamp bars (B)
and cam rods (C). Do not remove guide
blocks (E) from aligning bar.
NOTE: MBRTA cannot be used to install
single or double-plate BR-10 or BR-14
fasteners. Refer to RSP310.
4. Insert a clip between first and second plates
at each end of the fastener strips. Insert clips on
both sides of center plate of each fastener strip.
3. Starting at the right side of the tool, place
proper number of fasteners on anvil plates
(F) with Flexco
®
facing up.
F
H
G
C
D
A
E
B
B
X2066
5. Insert cam rods (C) through holes in clips
across bottom of tool.
6. Turn cam rods (C) to lock fasteners in
place. Secure cam rods (C) to channel base
handle (D) with pin.
7. Turn over aligning bar (A) and align guide
blocks with bottom plates. Place top plates
on guide blocks, Flexco
®
facing up.
