Chemicar Europe NV - Baarbeek 2 - 2070 Zwijndrecht - België/Belgium
1
The values shown are based on a nominal voltage of 230V/50Hz. In the case of
voltages and frequencies of different power, values may vary. Refer to the label
technical specifications to the nominal values of the tool.
GENERAL WARNINGS
The safety and accident prevention instructions are reported in the “
SAFETY INSTRUCTION
” booklet
which forms an integral part of these documents. This
OPERATING INSTRUCTIONS MANUAL
indicates
the additional information required specifically for use of the tool.
CORRECT USAGE
This tool is designed to be used as a polisher. Read all the warnings, instructions, indications provided
on drawings and specifications supplied with this tool. Failure to comply with all the instructions provided
below may cause electrical shocks, fire and/or serious injuries. This tool is not intended to be used for
smoothing, metal brushing and cutting operations. The use of this tool for unintended applications may
cause hazards and injuries to people.
The tool must be used with accessories that have been specifically designed or recommended by the
manufacturer. The fixing of the accessory to the tool does not guarantee a safe operation. The rated speed
of the accessories must be at least equivalent to the maximum speed specified on the tool. Using the
accessories at speeds above the rated maximum, may cause them to break or be projected into the air.
The external diameter and thickness of the accessories must match the specifications of the tool.
Accessories with incorrect dimensions cannot be adequately protected or controlled. The configuration of
accessories must match the tool. The use of accessories that cannot be perfectly fitted on the tool may
result in imbalance, excessive vibrations and in the impossibility of controlling the tool.
Do not use damaged accessories. Before use, inspect all the accessories. Inspect the supporting pads and
verify there are no cracks, tears or excessive wear. If the tool or accessory has been dropped, verify that
it is not damaged or install a new accessory. After inspecting or installing an accessory, test the operation
of the tool at maximum speed and without load for one minute, keeping at a safety distance. If the
accessories are damaged, they will break during this test.
SAFETY WARNING APPLICABLE TO
POLISHING OPERATIONS
Verify that no loosened part of the polishing tool shroud or the locking ties can rotate freely. Safely
position or cut all the loosened fixing wires. Loosened or revolving fixing wires may twist around the
operator’s fingers or get caught by the work piece being machined.
POL 55
SAFETY & OPERATING
INSTRUCTION MANUAL
Electric polishing machine
220V-900W 700-2500RPM
Chemicar Europe NV - Baarbeek 2 - 2070 Zwijndrecht - België/Belgium
