myAirvo™ 2 Quick Start Guide
60
60
90
a
b
c
Nasal cannula
Auto-fill chamber
60
a. Remove the blue port
tabs and water supply
tube holder.
b.
Install the provided
elbow adapter to the
MR290 water chamber.
c. Clip the water supply
tube into position.
Please refer to Section 2, “Setting up myAirvo 2”, and Section 3, “Using myAirvo 2”, of your
myAirvo 2 User Manual for information on setup.
Please refer to Section 4, “Cleaning and maintenance”, of your myAirvo 2 User Manual for information on
consumable parts. myAirvo 2 has five parts which you will need to replace regularly to keep your device
as clean as possible. The times recommended below assume your myAirvo 2 is only being used by one
person, and rely on the correct cleaning procedures being followed.
1
2
Op nasal cannula
Replace every 60 days.
Product code: MYOPT9SMALL (2-pack)
MYOPT9MEDIUM (2-pack)
MYOPT9LARGE (2-pack)
AirSpiral™ tube and auto-fill chamber kit
Replace every 60 days.
Product code: MYAIRVOKIT1
Reorder code:
Air filter
Replace every 90 days or 1000 hours.
Product code: 900PT913 (2-pack)
Water bag
Replace every 60 days.
Product code: 900PT401 (2-pack)
Important note: This is a Quick Start Guide only and should not be considered in any way a replacement
for your myAirvo 2 User Manual. Before using your myAirvo 2 device you must read your myAirvo 2 User
Manual to understand the device’s intended use, warnings and cautions. myAirvo 2 is not intended for life
support.
Some products may not be available in your country.
Please contact your local Fisher and Paykel Healthcare representative.
Place your myAirvo 2 on a
low shelf or near the floor
beside your bed. Make
sure it is placed below your
head height and flat.
REF 6
129
70 REV D 20
21-
10
©
20
21 Fisher & P
ayk
el Healthcar
e Limit
ed
Contact details for support and ordering
www.fphcare.com/myairvo
4. Consumable parts
1. How to set up your device
Fit the water chamber onto
your device by depressing
the finger guard, pushing
forward until the finger
guard clicks into place.
3
a
b
a. Hang water bag from
the home stand.
b. Push water supply tube
spike into the fitting at
the bottom of the water
bag. Open vent cap.
c. Water will enter MR290
water chamber and be
contained below the
max water level line.
4
Attach the breathing tube
to your myAirvo 2.
5
Plug myAirvo 2’s power
cord into the mains/utility
power socket and into the
rear of the unit.
6
Switch on myAirvo 2 by
pressing and holding
the On/Off button for 5
seconds.
7
myAirvo 2 will begin to
warm up, displaying a
warm-up symbol on the
screen.
8
When myAirvo 2 is ready
for you to use, a tick
symbol will be displayed.
9
Connect your interface
and begin therapy. During
use, if excess condensate
forms in the tube, refer to
Condensate Management
in Section 2, “Setting up
myAirvo 2”.
10
F&P, AirSpiral, myAIRVO, myAirvo and Optiflow are trademarks of Fisher & Paykel Healthcare Limited.
For patent information, see www.fphcare.com/ip
