Adirondack Glider Additional Assembly Instructions
1. Turn assembled Adirondack upside down on a flat table top as shown.
2.Attach base leg supports to front and base legs.
Insert two 1
¾
” screws through
front (square end) of one base leg support until tips show. Also insert one 1
¾
” screw
and one 3” screw through back of base leg support as shown in the photo until the tip
of the 1
¾
” screw shows. Apply glue and line up screws to pre-drilled holes on inside
of front leg and bottom of base leg. Tighten screws. Repeat for second base leg
support on other side.
Unpack and examine all additional parts,
which consist of:
1 each: Glider base frame with swing arms
2 each: Adirondack base leg supports
1 each: Additional hardware
1 each: Assembly instructions
NOTE: BOTH BASE LEG SUPPORTS ARE
LABELLED FOR CORRECT ALIGNMENT.
