1
IMPO
RTAN
T:
IMPO
RTAN
T:
Go to www
.extron.com f
or the complete
user guide
, installation instructions,
and
specifications bef
ore connecting the
product to the po
wer sour
ce.
DTP HDMI 330 • Setup Guide
This guide provides quick start instructions for an experienced installer to set up and operate the Extron DTP HDMI 330 digital video
extender. The DTP HDMI 330 transmitter and receiver pair can extend an HDCP-compliant HDMI signal up to 330 feet (100 m).
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources and mount the Tx and Rx units as required.
Step 2 — Connections
a
HDMI Input connector (Tx)
— Connect an HDMI cable
between this port and the HDMI output port of the digital
video
source.
NOTE:
See the “
“ on the back of this guide for to
securely fasten the input HDMI connector to the transmitter.
b
Audio input (Tx)
— Connect an unbalanced stereo audio source to this 3.5 mm mini
stereo jack for an analog audio input.
c
RS-232 and IR connectors
— To pass serial or infrared data or control signals, such as
serial control of a projector, connect the primary device to the transmitter and the secondary
device to the receiver via the RS-232 and IR captive screw connectors on both units.
d
DTP RJ-45 connectors
— Connect transmitter DTP Out to receiver DTP In.
Extron recommends that you terminate both cable ends in accordance with the following
specifications, at a minimum:
•
TIA/EIA T 568 B
•
CAT 6A, shielded
•
24 AWG, solid conductor
ATTENTION:
•
Do not connect these devices to a computer data or telecommunications network.
•
Ne connectez pas ces appareils à un réseau de télécommunications ou de données
informatiques..
Signal LED
— Lights when the unit is receiving a TMDS clock signal on the HDMI input (transmitter) or
any valid signal on the DTP In connector (receiver).
Link LED
— Lights when a valid link is established between the units on the DTP cable.
e
HDMI Output connector (Rx)
— Connect a display with an HDMI input for display of the
transmitted direct digital image.
NOTE:
See the “
“on the back of this guide for to securely fasten
the output HDMI connector to the receiver.
DTP HDMI 330 Tx Rear Panel
DTP HDMI 330 Rx Rear Panel
Front Panel
DTP HDMI 330 Rx
OVER DTP
RS-232
IR
Tx Rx
Tx Rx
G
L
R
POWER
12V
0.7A MAX
AUDIO
SIG LINK
DTP IN
OUTPUTS
AUDIO
INPUTS
OVER DTP
RS-232
IR
Tx Rx
Tx Rx
G
POWER
12V
0.7A MAX
SIG LINK
DTP OUT
3
6
3
7
7
1
5
4
4
2
5
Pin
1
2
3
6
7
8
4
Wire color
White-green
Green
White-orange
White-blue
Orange
White-brown
Brown
Blue
TIA/EIA T568B
TP Wires
12345678
Pins:
Ground
Receive pin on connected unit
Transmit pin on connected unit
Connected RS-232
and IR Device Pins
Tx/Rx
Pins
Receive pin on connected unit
Transmit pin on connected unit
RS-23
2
IR
Tx
Rx
Tx
Rx
G
L
R
AUDIO
OUTPUTS
AUDIO
INPUTS
