*Please see separate Smart Switch Sub-Assembly
manual for complete instructions.
Smart Relay
×
1
Fixing Screw
×
1
Double Sided Foam
Pad
×
1
Instruction Manual
×
1
Product Introduction
Smart Relay uses Zigbee wireless technology
and may be used in different loads, including
incandescent lamps, halogen lamps, LED lamps
and fluorescent lamps. It is small in size and may
be installed in the box of light fixtures. This device
is compatible with standard Zigbee 3.0 gateway
or devices for remote control and inter-operation.
Technical Specifications
Model
SRB01
Input Voltage
AC 85V~245V
Max. Load Power
AC 110V/300W
AC 220V/600W
Min. Load Power
No limit
Type of Load
Lighting
Operating Temperature 0~40°C
(32°~104°F)
Operating Humidity
5~85% RH
Wireless Connectivity
Zigbee 2.4GHz IEEE 802.15.4
Zigbee Profile
Zigbee 3.0
RF Characteristics
Operating frequency: 2.4GHz
Range: 30m~60m
Internal antenna
Product Size (L*W*H)
59.4mm * 39.3mm * 21.2mm
(2.34in. x 1.55in. x 0.83in.)
Device Identification QR Code (Zigbee)
Complete Accessories Include
Caution: Read this manual before attempting to install the device! Using this product in a manner other than
intended voids your warranty. Further, Evvr ApS is NOT liable for any damage incurred with the misuse of this
product.
Caution: All installations of this device should be performed by a qualified or licensed electrician!
Caution: Product must be installed on a 10A line.
Caution: Metal casings, mirrors, electrical appliances, etc., may affect, reduce, or interfere with wireless
communication.
Installation Instructions
Caution: If you have purchased a Smart Switch Sub-Assembly
to use with it, please follow the installation instructions on the
Smart Switch Sub-Assembly manual.
With Smart Relay, you can turn a traditional lamp into a Zigbee
smart lamp. It is recommended to install Smart Relay near the
lamp.
Warning: Turn OFF electrical power from the breaker box or
electrical service panel before installing or servicing this
product. Improper use or installation can cause SERIOUS
INJURY, DEATH, or LOSS/DAMAGE OF PROPERTY.
Caution:
Use this product in
an indoor
environment.
N
L OUT 1
L
LOAD
N
N
L OUT
L
LOAD
You can choose one of the two diagrams below to connect the
wires according to your installation environment.
NOTES FOR THE DIAGRAM:
N - neutral wire L - live wire L OUT - output live wire
Stick the foam pad at the recommended position on the Smart
Relay and then place the relay on a flat, cleaned surface.
Turn ON electrical power and check if the wires are connected
correctly. If they are correct, the indicator light will be on when the
load light, the light(s) connected to the switch, is on.
Recommended
placement
2
Fix Smart Relay on a flat, cleaned surface
1
Connect wires per wiring diagram as follows
OUT
Output for load
L
Power input for
live wire
N
Power input for
Neutral wire
Indicator Light
Fixing hole
Fastening screws
RESET Button
Instruction
Manual
In-Wall Relay Switch
Smart Relay (Zigbee version)
Instruction Manual
Rev. B-092822
P/N SRB01
