background image

ES34T

SECURITY MOTION SENSOR

 

PIR (Motion Sensor )

 

PIR Lens

INTRODUCTION

Your EVERSPRING SECURITY MOTION SENSOR is a
fully automatic outdoor security/courtesy light controller
capable of controlling up to 1000W of lighting. At night,
the built-in passive infrared (PIR) motion sensor turns on
the connected lighting system when it detects motion in
its coverage area. During the day, the built-in photocell
saves electricity by deactivating the lights. An adjustable
timer lets you select how long the light stays on after
activation.

Two operation options - let you choose automatic
operation or manual override based on the ambient light
level.

Note : Read this entire manual before you start to
install the system.

SAFETY PRECAUTIONS

 

l

 

Do not install when it is raining.

l

 

Be sure to switch off power source before installing.

l

 

Make sure that the power wiring comes from circuit
with an external 16A miniature circuit breaker for the
short circuit protection or a suitable fuse.

l

 

The unit can be installed only horizontally (see the
FIGURE 1a), not vertically (see the FIGURE 1b) as
shown in the below drawing.

HORIZONTAL         VERTICAL

FIGURE 1a & 1b

IMPORTANT

Some local building codes may require installation of
this product by a qualified electrician.

Check your local codes as they apply to your situation.
If the house wiring is of aluminum,
consult with an electrician about proper wiring
methods.

Before proceeding with the installation, TURN OFF
THE POWER TO THE LIGHTING CIRCUIT AT
THE CIRCUIT BREAKER OR FUSE BOX TO
AVOID ELECTRICAL SHOCK.

CHOOSING A MOUNTING LOCATION

 

l

 

For the best results, fix your sensors on a solid
surface. For wall mounting, 1.8~2M above the
ground is needed. For ceiling mounting, 2.5~4M
above the ground is required.

l

 

For outdoor installation, a location under eaves is

     preferable.

l

 

Avoid aiming the motion sensor at pools, heating
vents, air conditioners or objects which may change
temperature rapidly.

l

 

Do not allow sunlight to fall directly on the front of
unit.

l

 

Try to avoid pointing the unit at trees or shrubs or

where the motion of pets may be detected.

1

Summary of Contents for ES34T

Page 1: ...uit protection or a suitable fuse l The unit can be installed only horizontally see the FIGURE 1a not vertically see the FIGURE 1b as shown in the below drawing HORIZONTAL VERTICAL FIGURE 1a 1b IMPORTANT Some local building codes may require installation of this product by a qualified electrician Check your local codes as they apply to your situation If the house wiring is of aluminum consult with...

Page 2: ... Type I FIGURE 4 Type II FIGURE 5 2 Note The detection angle of ES34T can come up to180 However to reduce or localize its detection coverage use the small plastic slip s provided to cover up part s of the LENS thus reducing its detection angle FIGURE 6 FIGURE 6 WIRING INSTRUCTION 1 Switch off the power source or wall switch 2 Unscrew two front screws to detach the base cover from the unit FIGURE 7...

Page 3: ...ight will turn on for about 1 minute to warm up Then it turns off l Walk through the detection area The light turns on when you move and turns off when you stop Wait for the light to turn off before moving again to test the sensor l Adjust the motion sensor to cover the desired detection area For a smaller coverage area point the sensor down for a larger coverage area point the sensor up 2 TIME AD...

Page 4: ...it back on TROUBLESHOOTING Light does not turn on l Confirm that you have made a correct wiring connection l Make sure that the bulbs have not burned out Light remains on l Make sure the wiring connection is correct l If you set the system to manual override remember that you must turn the wall switch off for at least 10 seconds to switch the sensor to automatic operation and turn off the lights l...

Reviews: