All rights reserved. Reproduction as well as electronic duplication of this user guide, complete or in part, requires the written consent of
ESERA GmbH. Errors and technical modification subject to change.
ESERA GmbH, ESERA-Automation 2020
www.esera.de
11208 V2.0 R1.0 Manual
Page 1 of 7
Art. No. 11208
User Guide
Analog Output 0-10VDC
for 1-Wire Bus system
1-Wire to analog output 0-10V
8 Bit resolution of the DA-converter
Galvanic isolation of analog output and
1-Wire network
LED-display for power and data update
DIN rail housing for control cabinet installation
analog- and digital areas with complex internal power supplies
Connection via screw terminals
Easy to assemble and easy software integration
Output protected against overload
and short circuit
1
Introduction
Before you start assembling the Analog Output and before you take the device into operation, please read these
assembly and operating instructions carefully to the end, especially the section referring to the safety notes.
2
Product description
With the Analog Output, a DC voltage in the range of 0-10V with a resolution of 8 bits can be easily output. This
DC voltage can be output for control, e.g. of a heating mixer, dimmer or other power control units.
The analog output is galvanically isolated from the 1-wire bus and the power supply. The isolation avoids ground
loops or effects due to potential differences.
3
Auto-E-Connect® Support
The ESERA
Auto-E-Connect®
1-Wire Plug and Play system will be used for the
1-Wire Bus supported. This enables fully automatic configurations of 1-Wire sensors
and actuators on the 1-Wire bus. It is optimized for industrial applications and
enables significant added value beyond the sensor and chip data.
The Auto-E-Connect function automatically recognizes ESERA chips, sensors and actuators, starts suitable
libraries and outputs fully formatted data.
The Auto-E-Connect functionality will be available from mid-2020 via 1-Wire Controllers, 1-Wire Gateways and
1-Wire ECO from ESERA available.
Further information on ESERA Auto-E-Connect can be found on the ESERA website, ESERA Config-Tool 3, or in
the download area for this article in the ESERA Webshop.
