6
Release the scanner support and lower the scanner.
7
Press the
Cancelar
(Stop) button to charge the ink. Charging takes
about 2 minutes.
Caution:
Don’t turn off the TX110 while it is charging or you’ll waste ink.
Unpack
If anything is missing, contact Epson as described on the back of this sheet.
Caution:
Do not open the ink cartridge package until you are ready to install the ink.
Cartridges are vacuum packed to maintain reliability.
Remove all the protective materials.
1
Start Here
Read these instructions before using the printer.
3
Install cartridges
Caution:
Keep ink cartridges out of the reach of children and do not drink the ink.
Note:
The ink cartridges that come with your printer have a lower yield due to the ink
system charging process. This process is carried out the first time you turn on your
printer and guarantees better performance.
Don’t load paper before installing ink cartridges.
1
Lift up the scanner and prop it up with the support.
2
Shake the ink cartridges, then unpack them.
3
Remove only the yellow tape from each cartridge.
Caution:
Do not remove any other seals or the cartridge may leak.
4
Insert the cartridges in the holder for each color.
5
Press each cartridge down until it clicks.
3
Flip the feeder guard forward. Then squeeze the edge guide and slide
it left.
4
Load paper against the right edge and underneath the tab, then slide the
edge guide over.
A4, Letter
4 6
Note:
Don’t load the paper sideways; always load
it short edge first.
5
Flip the feeder guard back.
Epson Stylus
®
TX110
4
2
Turn on the TX110
1
Connect the power cable.
Caution:
Do not connect to your computer yet.
2
Press the
Encender/Ligar
(On) button.
*411585200*
*411585200*
Load paper
1
Open the paper support.
2
Open the output tray and pull out the extension.
