3
Remove and reinsert the maintenance cartridge.
4
Close the ink cartridge covers.
5
Connect the power cord.
6
Press the
power button on the printer.
7
The printer starts charging the ink. This takes about 20 minutes.
Caution:
Do not turn off or unplug the printer while the power light is flashing.
Also, do not open the ink cartridge covers or scrap paper box during the
charging process.
Note:
The first time you install ink cartridges, the printer uses some ink to
charge the printing system, so print yields may be lower with the first
cartridges. Subsequent ink cartridges will last for their full rated yield.
Epson
®
SureLab
®
D870
Start Here
IMPORTANT: Before using this product, make sure you read these instructions
and the safety instructions in the online Operation Guide.
Choose a location for the printer
Choose a location for the printer that is near a wall outlet where the power cord
can be easily unplugged. Avoid places subject to rapid changes in temperature
and humidity. Also keep the printer away from direct sunlight, strong light, or
heat sources.
Make sure to place the printer on a flat, stable surface with enough space on
all sides.
13.9 in.
(354 mm)
1.2 in.
(30 mm)
1.2 in.
(30 mm)
16.9 in.
(430 mm)
1.2 in.
(30 mm)
18.1 in.
(460 mm)
11.8 in.
(300 mm)
Unpack
1
Make sure you have these items:
Power cord
Printer
Limited
warranty
Note:
Ink cartridges are not included.
2
Remove all of the packaging materials and tape from the outside of the
printer.
3
Remove the scrap paper box.
4
Remove all the packaging materials and tape from inside the roll paper
feeder.
5
Grip the handle to release the roll paper feeder and pull it out.
6
Remove the spindle and set it aside.
7
Push the roll paper feeder back into the printer.
8
Reattach the scrap paper box.
9
Open the ink cartridge covers and remove the packaging materials and
tape from inside the printer.
Install ink cartridges
1
Remove the ink cartridges from their packages.
Caution:
Do not touch the green chip on top of the cartridge.
2
Insert each cartridge into the correct slot for its color.
Load paper
1
Make sure the printer is on.
2
Stand the spindle on its side and remove the gray adapter.
3
Remove the paper roll from its packaging. Remove any tape and
protective paper from the end of the roll.
4
Stand the paper roll on its side and wipe the edge of the paper roll with
a soft, clean cloth several times to remove any dust. Flip the paper roll
and repeat the process.
5
Place the paper roll on the spindle unit so that the paper winds
clockwise, then insert the gray adapter onto the spindle. Press down
until there is no gap between the adapter and the roll paper.
6
Remove the scrap paper box.
7
Grip the handle to release the roll paper feeder and pull it out.
