background image

Liebert  GXT2-10KIPPCBL

Quick-Start Guide

Warnings

& Cautions

This input power cable 
must be installed only 
by properly trained and 
qualified personnel.
Opening or removing 
the cover of the UPS 
may expose you to lethal 
voltages within this unit 
even when it is appar-
ently not operating and 
the input wiring is dis-
connected from the elec-
trical source. Observe all 
cautions and warnings 
in this quick-start guide 
and in the user manual 
for the UPS, available 
at the Liebert Web site, 

www.liebert.com

Failure to do so may re-
sult in serious injury or 
death.

Disconnect the Liebert GXT2-10000RT208™ from all electri-

1. 

cal inputs.

Remove the top cover from the terminal block cover on the 

2. 

rear of the UPS. Set all screws aside for reinstallation.

Use a screwdriver or similar tool to remove the knockout.

3. 

Slip the locknut onto the input power cable.

4. 

Thread the input power cable through the knockout hole.

5. 

Slip the fixed ring onto the input power cable.

6. 

Connect the wires of the input power cable to the input 

7. 

power terminal block of the UPS according to the labels on 

the wires (see Connect cable wires, below).

Each wire must be connected to the corresponding location 

8. 

on the input side of the terminal block.

Reattach the terminal block cover to the Liebert GXT2-

9. 

10000RT208 using screws removed in Step 2.

Leave a small amount of slack in the input power cable 

10. 

inside the terminal block and secure the cable to the 

terminal block with the fixed ring and locknut (see Secure 

cable to back cover, below).

Reattach the top cover to the terminal block using screws 

11. 

removed in Step 2.

Check the voltage of the input power supply to ensure that 

12. 

it matches the power requirements of the Liebert GXT2-

10000RT208.

If the input power is correct, shut off power to the supply 

13. 

socket and mate the UPS to the socket.

L2

L1

N

OUTP UT

INP UT

60  Amp Max Branch

Overcurrent Protection

L2

L1

N

L2

L 1

N

N

L2

L1

G

Wires are labeled

Connect cable wires

Secure cable to back cover

Reattach terminal

 block cover

®

Reviews: