background image

97256C Rev. A 4/05

EDF14C

Installation/Care/Use Manual

To assure you install this model easily and correctly, PLEASE READ THESE SIMPLE
INSTRUCTIONS BEFORE STARTING THE INSTALLATION. CHECK YOUR INSTALLA-
TION FOR COMPLIANCE WITH PLUMBING, ELECTRICAL AND OTHER APPLICABLE
CODES. After installation, leave these instructions inside the fountain for future reference.

15

SEE FIG. 2

INSTALLATION INSTRUCTIONS

1.  Wall

 should already be framed for the fountain using the positioning dimensions shown in Figure 1.  Shown dimensions pertain to

    installation location (framing must support up to 150 lbs. weight).

2.  Install

 rough-in plumbing as shown in Figure 1.  Waste line should extend a minimum of 2" (51mm) through the back panel. Connect

    ing lines to be copper and thoroughly flushed to remove all foreign matter before connection to fountain. Run the supply water inlet
    line through the back panel.  Install a service stop (not provided).  Turn on supply water and flush thoroughly.

3.  Secure

 the fountain to the wall using (6) bolts and washers (not provided).  Tighten securely.

4.  Remove

 elbow from end of p-trap and attach it to drain tube.  Reattach elbow to p-trap and cut waste tube to required length

     using plumbing hardware and trap as a guide.

5.  Make

 water supply connections from service stop to the fountain.  Turn on water supply and check for leaks. Newly installed

     water supply line should be insulated after leak check is completed.

6.  These

 products are designed to operate on 20-105 PSIG supply line pressure.  If inlet pressure is above 105 PSIG, a pressure

     regulator must be installed in the supply line.  Any damage caused by reason of connecting these products to supply line pres
     sures lower than 20 PSIG or higher than 105 PSIG is not covered by warranty.

7.  Check

 stream height from bubbler.  Stream height is factory set at 35 PSI.  If supply pressure varies greatly from this, turn

    adjustment screw on the regulator (Item 5). Clockwise adjustment will raise stream height and counter-clockwise will lower stream
     height.  For best adjustment stream should hit basin approximately 6-1/2" (165mm) from bubbler.

TROUBLE SHOOTING AND MAINTENANCE

1.  Orifice Assy:

  Mineral deposits on orifice can cause water flow to spurt or not regulate.  Mineral deposits may be removed from

     orifice with a small round file not over 1/8" diameter or a small diameter wire.  

CAUTION:

  Do not file or cut orifice materials.

IMPORTANT

ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON

IMPORTANT! INSTALLER PLEASE NOTE.

THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. TO
WATER LINES IS A COMMON PROCEDURE. THIS GROUNDING MAY BE IN THE BUILDING OR MAY
OCCUR AWAY FROM THE BUILDING. THIS GROUNDING CAN CAUSE ELECTRICAL FEEDBACK INTO A
FOUNTAIN, CREATING AN ELECTROLYSIS WHICH CAUSES A METALLIC TASTE OR AN INCREASE IN
THE METAL CONTENT OF THE WATER. THIS CONDITION IS AVOIDABLE BY USING THE PROPER
MATERIALS AS INDICATED. ANY DRAIN FITTINGS PROVIDED BY THE INSTALLER SHOULD BE MADE
OF PLASTIC TO ELECTRICALLY ISOLATE THE FOUNTAIN FROM THE BUILDING PLUMBING SYSTEM.

Installer

Reviews: