The
Standard Outdoor Pushbutton
Timer (3 wire) is part of the Elkay
family of switches, timers and
detectors which save energy and
increase convenience in and around
your home, garden or premises.
Rating at 240V ac 50Hz
•
Time Delay: 2 min - 1 hour
•
Lighting load types only 10A - Including
lighting loads that are LED, Compact
Fluorescent, Incandescent and Resistive
•
This switch can also switch contactors
provided a capacitor is fi tted across
the coil
•
IP66
Fitting and Operating Instructions
This product can ONLY be used with the
back box supplied and can be used in
outdoor and bathroom applications.
Failure to use the back box provided will
invalidate the warranty. It is essential that
that the correct IP66 rated connections
are made to keep the IP66 rating of
the back box maintained.
1. Take the surface mount box and remove
knockouts as required. Ideally remove
with a hole saw for cleanest eff ect and
remove any burrs. Drill a small 3mm
drain hole at the back of the box in the
position marked ‘DRAIN‘. Drill outwards
from the inside of the box.
2. Mount the surface mount box on a secure
surface using the mounting pack supplied.
Place screw cover seal over the rear
mounting screws after screwing the box
to the wall.
3. It is essential to maintain the IP rating with
all connections to the box. Please use a
suitable M20 cable gland and use
appropriate sealing washers. For steel wired
armoured connections to the box use a nylon
20mm seal to maintain IP rating. Seals have
been provided for your convenience.
4. Prior to fi tting ensure mains power is
switched OFF and live in, live out and neutral
wires are identifi ed. Where applicable
remove metal back box lugs that are
not being used.
5. Securely fi t live in, live out and neutral
wires into terminals marked Lin, Lout & N.
–
STANDARD
OUTDOOR
PUSHBUTTON
TIMER
550B-1
3 wire
Instruction Guide
BROOK DESIGN HARDWARE LTD
B
D
H
B
D
H
BROOK DESIGN
HARDWARE LTD
B
D
H
BROOK DESIGN
HARDWARE LTD
BDH
BROOK DESIGN
HARDWARE LTD
B
D
H
