E F A P O W E R E V - Q C 4 5 - I N S T A L L A T I O N A N D U S E R M A N U A L
7 | 32
5
INSTALLATION
All matters for installing the EFAPOWER EV-QC45 are described in this chapter.
5.1
ENVIRONMENTAL REQUIREMENTS
EFAPOWER EV-QC45 reliability is dependent upon compliance of environmental specifications. The design of the
environmental control system for your EFAPOWER EV-QC45, in case of extreme environmental conditions, must
ensure that the Unit can operate reliably while remaining within the range of its operating specifications.
5.1.1
LOCAL CONDITIONS
The installation of EFAPOWER EV-QC45 shall not be made in a commercial garage (repair facility) or
closer than 6,1m (20 feet) of an outdoor motor fuel dispensing device.
EFAPOWER EV-QC45 is in an IP54, IK10 (NEMA 3R) enclosure. This Unit is intended to work below 50ᵒC (122ᵒF)
ambient temperature.
Clearance around the cabinet
The air must circulate freely throughout the ventilation grids in order for
the charger’s cooling system to be
effective. The ventilation areas on the sides and back must not be blocked, assuring that the Quick Charger
cooling system can be effective. Efacec recommends clearance of at least 1meter (40’’) in the front (HMI
interfa
ce) and on right side (output cables) and 500mm (20’’) of clearance in the remaining sides of the cabinet.
Input Power Cables
AC input cables must be copper with appropriate power rating.
EFAPOWER EV-QC45 can be placed in 3 alternative positions as showed in Figure 5.
Figure 5 - EFAPOWER EV-QC45 alternative orientations
