![background image](http://html1.mh-extra.com/html/edelbrock/endurashine-63-0299/endurashine-63-0299_installation-instructions_2357628001.webp)
© 2006 Edelbrock Corporation
Brochure #63-0299
Rev. 5/06
MAINTENANCE & CARE INSTRUCTIONS FOR
ENDURASHINE
™
& PERMASTAR
®
PARTS
Congratulations, you have purchased a superior product from America’s premier Automotive Aftermarket Manufacturer - Edelbrock.
With the proper care and cleaning, your EnduraShine or PermaStar parts will continue to look good and keep their high gloss shine
for years.
CLEANING OR REBUILDING YOUR CARBURETOR:
NEVER
clean your EnduraShine or PermaStar parts with solvents or carburetor cleaners of any kind. Use of these cleaners will dull
the luster and will remove the coating. Never use solvents or carburetor cleaners when rebuilding your EnduraShine carburetor. Do
not use paper towels to wipe or clean your EnduraShine or PermaStar parts. Although we test our coated products with various fuel
types, gasoline formulations may stain the EnduraShine or PermaStar coating. In all cases, take extra care to prevent gasoline from
covering the manifold or exterior of the carburetor.
Please note that special care needs to be given when using Holley or Demon carburetors that have end bowl gaskets below the fuel
level that may facilitate leaking of gasoline.
ALWAYS
clean your EnduraShine or PermaStar parts using mild soap, water or non solvent cleaners such as Simple Green. Use of
products such as Novus No. 1 Plastic Clean & Shine or other products listed below will help keep the shine and act as a dust
repellent. When cleaning always use a clean, soft cotton, non-abrasive, absorbent, lint-free, micro-fiber cloth and a short circular
stroke cleaning motion.
SCRATCH REMOVAL:
DO NOT
use a chrome polish or a scratch remover that is not clear coat safe.
For best results, a high quality polish such as Novus No.2 Fine Scratch Remover, Meguiars or Mothers Plastic Polish should be used.
Before the application of any scratch removal product ensure the surface of the part is clean and free of any dirt or grime and follow
the directions of the cleaning product carefully.
NOTE:
Any cleaning products used on your EnduraShine or PermaStar parts
MUST
be clear coat safe or developed for the cleaning of acrylic
coatings. We suggest applying any automotive wax coat after cleaning, this will help to seal the surface and protect the finish.
Use
of abrasive or solvent cleaners will void your manufacturer’s warranty.
IMPORTANT INSTRUCTIONS
USE the products listed below to clean
your EnduraShine or PermaStar Parts
Cloth Towels
Microweave Cloth
Soap & Water
Simple Green
®
Turtle Wax
®
Wash & Wax
Automotive Paint & Finish Cleaner
Novus
®
Plastic Shops & Detail Supply Shop
Meguiars
®
Plastic Polish & Cleaner
Meguiars
®
Cleaner Wax
Mothers
®
Plastic Polish
Mothers
®
California Gold Wax Products
DO NOT USE the products listed below to
clean your EnduraShine or PermaStar Parts
Paper Towels
Scouring Pads (Scotch Brite)
Steel Wool
Carburetor Cleaner
Any Petroleum Based Solvents
Chrome Polish or Cleaner