C22HD & C22HDS
B
roadcast
s
preader
ASSEMBLY and OPERATING INSTRUCTIONS
31104
Qty 4
36300
Qty 17
36305
Qty 2
36404
Qty 18
36200
Qty 4
36205
Qty 3
36207
Qty 2
33117
Qty 1
36105
Qty 1
36104
Qty 1
36103
Qty 1
36209
Qty 4
For
C24HD
Only
Upper Handle
Gauge & Lever
Handle
Shaft
Frame
Brace
Cross
Brace
Lower
Handles
Impeller
Frame
Gearbox
Pivot
Control
Rod
Pivot
Rod
Axle
(Qty 4) #31104
#14 X 1½”
Flat Head Screw
2.
Position hopper on side. Install
frame using (4) #14 x 1½” Flat
Head Phillips screws.
TIGHTEN
THESE NOW.
1.
Remove and identify all of the loose parts from carton.
6-2014 Pt# 52153
PAGE 1
Gauge Overlay is snapped over the
metal gauge. Replace the stop bolt
assembly to secure overlay on the
gauge.
WARNING
Do not use air tools to assemble. To prevent seizing,
spray all nuts & bolts with oil, grease, wax, or other
lubricant.
PLEASE CALL
IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS
REGARDING THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME TECHNICAL SUPPORT
SUPPORT HOT LINE: 574-848-7491 or 800-294-0671, email: [email protected]
HELPFUL HINTS:
;
If your spreader does not spread evenly, be sure the FRONT on the gear box points to the front of the spreader. The impeller must
turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller after each use as some
fertilizer may become stuck on the impeller blades and will cause uneven spreading.
;
Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds will change
the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean and dry your spreader thoroughly after each
use. To prevent rust, please coat all metal surfaces, also inside tubes where possible, with a light oil or WD-40. Wash between the shut
off plate and bottom of the hopper.
;
Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
;
If you use
Rock Salt
remove the agitator to prevent damage to the gearbox and remove salt from the hopper daily.
Rock Salt
will
reconstitute back into a solid block over night and will damage your spreader.
ROCK SALT and POWDERED
MATERIALS should not be used in this
spreader as it will damage gearbox and can
void warranty.
Use only granular materials.
IF YOUR SPREADER COMES SEMI ASSEMBLED, SKIP TO STEP #6
MADE IN THE USA
