4. Attach Kick Plate(D) to Divider Section(C) using 4 Phillips
Head Screws(G). Tighten with Phillips Head Screwdriver.
2A. On a carpet or protected surface, carefully lay Right Side
Panel(A2) face down as shown.
2B. Position the assembled Divider Section(C) and Kick Plate(D) so the
pre-installed wooden dowels in the sides enter holes in the Right Side
Panel(A2) as shown.
Mount Laurel,NJ 08054 USA
www.ecr4kids.com
Single Sided Book Display
(Laminate)
Model#: ELR-0638
A1
A2
B
C
D
E
F
G
1
3
Attach the Divider Section to
the Right Side Panel
2
Attach Right Side Panel to
Back Panel
B
A2
1. Attach Right Side Panel(A2) to Back Panel(B) using 3 Hex Head
Screws(E). Tighten with Hex Key Tool(F).
B
A2
B
D
C
Left Side Panel
Right Side Panel
Back Panel
Divider Section
Kick Plate
Hex Head Screw(10)
Hex Key Tool
Attach Kick Plate to Dividers
X4
Phillips Head Screw(4)
G
X3
E
4
!
WARNING:
-
Adult Assembly Required.
Two
adults recommended.
- Contains small parts, sharp points
and edges.
- Do not stand, sit, kneel, climb, lean
or pull on unit for support.
- Never leave children unattended.
- Do not place unit near high heat or
moisture.
- Adult Supervision Recommended.
If you experience any difficulties
with this product, please contact us
toll free at 1-888-227-9028
(Monday through Friday,
9:00am to 5:00pm Eastern Time).
Please do not return
to place
of purchase as Early Childhood
Resources will replace defective
parts and/or product.
TIP!
DO NOT FULLY TIGHTEN SCREWS UNTIL ALL
SCREWS HAVE BEEN LOOSELY POSITIONED.
BEFORE ASSEMBLING, MAKE SURE
THERE ARE NO MISSING PARTS.
NOTE:
A Phillips Head Screwdriver
may be used for
assembly (not included)
3. Attach Left Side Panel(A1) to the assembled unit, be sure all
the pre-installed wooden dowels in left side enter holes in Left
Side Panel (A1).Using 5 Hex Head Screws(E), and tighten with
Hex Key Tool(F).
A2
A1
A1
Version: ELR-0638_AI.D.2010.01.03
X5
E
D
C
B
A1
A2
B
A2
B
A2
C
D
D
D
C
B
A1
A2
Attach Left Side Panel
