![background image](http://html1.mh-extra.com/html/dynex/dx-rad01/dx-rad01_quick-manual_2550437001.webp)
QUICK SETUP GUIDE
FM/AM Pocket Radio - DX-RAD01
Package contents
• Radio
• Wrist Strap
• Earphone
•
Quick Setup Guide
Features
Tuning LED
FM antenna
Wrist strap hole
Tuning dial
Volume
switch
Band
switch
Power ON/OFF
Battery door
Tuning display bar
Speaker
Earphone jack
Wrist strap hole
Installing the batteries (Not Supplied)
1
Open the battery compartment door located at the back of your radio.
2
Insert two AAA batteries into the battery compartment. Make sure the +
and - on the batteries match the + and - inside the battery compartment.
3
Replace the battery door.
Battery precautions
The radio will not work when the batteries are low. If this occurs, replace the
batteries.
• Danger of explosion if batteries are incorrectly replaced. Replace only with
the same or equivalent type.
• Use only the size and type of battery specified.
• Be sure to follow the correct polarity when installing the batteries
as indicated in the battery compartment. A reversed battery may
cause damage to the device.
• Do not mix different types of batteries together (e.g.Alkaline,
Rechargeable, and Carbon-zinc) or old batteries with fresh ones.
• If the radio is not to be used for a long period of time, remove the
batteries to prevent damage or injury from possible battery leakage.
• Do not try to recharge a battery not intended to be recharged; it can
overheat and rupture. (Follow the battery manufacturer's directions.)
• Exhausted batteries must be removed to prevent any battery leakage.
• Dispose of batteries properly according to environmental regulations.
• Battery (installed battery or battery pack) should not be exposed to
excessive heat, such as sunshine, fire, or the like.