DYMO 1570
Adjusting Space on Label Ends
For more blank spaces before and after messages
: Turn the tape feeder (B) .
For less blank spaces
: Turn the tape feeder (B) in reverse, emboss the message, turn feeder
forward, and cut.
To center a message
: Advance completed label 3 spaces (5 space for 1530 Office Mate I)
Squeeze tape cutter.
Troubleshooting
Label shows letters instead of blank space
: Squeeze handle half way until you hear a click,
then release.
Letters too light
: Squeeze harder by holding the upper end of the handle.
Tape jam
: In the unlikely event the tape does not feed properly, remove the tape wheel, discard
left over tape ends, and replace the wheel.
Preparing Problem Surfaces
Use non-residual solvents (i.e., alcohol, acetone) to clean oily or greasy surfaces. If the surface is
rough or porous, coat it with a sealer (i.e. shellac, lacquer). Once stuck, water will not affect the
label. Do not apply labels to surfaces exceeding 140 F.
