![background image](http://html1.mh-extra.com/html/duevi/dv-touch/dv-touch_manual_2538417001.webp)
DVTOUCH 20.02-M:1.0-H:01V3-19-F:1.00
DV-TOUCH Touch Screen Keyboard on bus RS485
DVTOUCH is a full screen touch screen keyboard (touch
sensitive) used for the control of CE100-3BUS or CE-LAN
control panels. The keyboard is connected to the control unit
via a 4-wire cable that includes power and RS485 bus
communication.
The keyboard screen turns on as soon as it is touched. If it
is not touched for 60 seconds (programmable time) the
screen turns off automatically.
The icons on the screen can change according to the control
panel to which the keyboard is connected (always refer to
the control panel manual).
The keyboard has a buzzer that emits acoustic signals
("beep"); it is possible to enable/disable the acoustic signals
and change the tone of the “beeps”.
The keyboard consists of two parts: a main body (1) and a
base (2), used for fixing to the wall.
1.
Identification of the parts
1 – Main body
2 – Mounting base
3 – Locking screw
4 – Release slots
2.
Installation
Do not use the device outdoors.
The keyboard must be installed on a flat surface using the
supplied mounting base. The main body (1) is hooked onto
the wall mounting base (2). Proceed as follows:
1.
Unscrew the locking screw on the lower side (3)
2.
Release the base levering on the slots on the lower
side (4)
3.
Fix the base to the wall with fischer screws (5),
passing the connection cable through the central part
(6). The base must be oriented with the locking screw
down (7).
5 – Wall fixing screws
6 – Cable routing
7 – Base orientation (locking
screw)
4.
Connect the four wires of the RS485 bus to the
keyboard terminal block (see the control panel manual)
5.
Reassemble the keyboard body on the base fixed to
the wall. Gently press until you hear the anchor clicks
of the 4 hooks.
WARNING: Arrange the connection cable in an orderly
manner, avoiding it being pinched during closing
6.
Tighten the locking screw on the lower side (3)
WARNING: Do not over tighten the screw - Use only
the screw supplied
3.
Dip-switch
DIP
ON
OFF
1
120 Ohm bus
termination
Termination
enabled
Termination
disabled
2
NOT USED
1
2
3
4
4
7
5
6
CLIC
K
CLIC
K
CLIC
K
CLIC
K