Dover unified brands groen DH-20 Operator'S Manual Download

Page: 1 / 30

OPERATOR MANUAL

IMPORTANT INFORMATION, KEEP FOR OPERATOR

THIS MANUAL MUST BE RETAINED FOR FUTURE REFERENCE. READ,
UNDERSTAND AND FOLLOW THE INSTRUCTIONS AND WARNINGS
CONTAINED IN THIS MANUAL.

FOR YOUR SAFETY

Instructions to be followed in the event user smells

gas. This information shall be obtained by consulting your local gas
supplier. As a minimum, turn off the gas and call your gas company and
your authorized service agent. Evacuate all personnel from the area.

WARNING

Improper installation, adjustment, alteration, service or

maintenance can cause property damage, injury or death. Read the
installation, operating and maintenance instructions thoroughly before
installing or servicing this equipment.

NOTIFY CARRIER OF DAMAGE AT ONCE

It is the responsibility of the

consignee to inspect the container upon receipt of same and to determine
the possibility of any damage, including concealed damage. Unified
Brands suggests that if you are suspicious of damage to make a notation
on the delivery receipt. It will be the responsibility of the consignee to file
a claim with the carrier. We recommend that you do so at once.

Manufacture Service/Questions 888-994-7636.

PART NUMBER 177049, REV. E (10/20)

This manual provides information for:

STEAM JACKETED KETTLE WITH STANDARD
ELECTRONIC IGNITION

MODELS DH(T)-20/40/60/80 &
DH(T)-20/40/60/80(C,A) DOMESTIC & CE

EQUIPMENT DESCRIPTION

The Groen DH is a floor-mounted, tilting, steam jacketed kettle with a
thermostatically or electronically controlled, self-contained, gas-heated steam
source and appropriate controls, mounted on a sturdy base. The Model DH is
available in 20, 40, 60 or 80 gallon capacities.
The body of the DH Kettle is constructed of stainless steel, welded into one
solid piece. The kettle is furnished with a reinforced rim and a butterfly shaped
pouring lip. It has a steam jacket which is ASME shop inspected and registered
with the national board for working pressures up to 50 PSI, 3.45 bars. Kettle
finish is 180 emery grit on the inside and bright high buff polish on the outside.
The kettle is tilted with a hand crank to pour out its contents. Stainless steel
panels enclose the controls and the base. Four stainless steel tubular legs
support the unit. Bullet or flanged feet on each of the legs can be adjusted to
level the kettle. Standard DHT units include a two inch tangent draw-off valve.
The self-contained steam source is heated by propane or natural gas. Ignition
is electronic.
The kettle is charged at the factory with chemically pure water which contains
rust inhibitors. The steam source provides kettle temperatures of 150º to
approximately 295ºF (65 to 150ºC). Unit controls include a thermostat or
controller, pressure gauge, safety valve, pressure limit control, low water cut-

off, power switch and gas regulator valve. The gas supply shuts off automatically
when the kettle is tilted.
The unit must be specified for use with natural or propane gas. Service
connections for gas and electricity are required. Standard power supply is 115
Volt (domestic) or 230V (CE). Alternate single-phase voltages (208-240V) are
available.

KETTLE DIMENSIONS

DH/DHT-20

DH/DHT-40

DH/DHT-60

DH/DHT-80

Kettle
Capacity

20 gal.

(75 ltr)

40 gal.

(150 ltr)

60 gal.

(225 ltr)