1
2
3
Description
The DMP 532XR Demonstrator is a portable, hand held keypad that allows you to simulate many of the
operational functions of a DMP command processor panel.
The 532XR operates in either the Area Arming, All/Perimeter, or Home/Away mode and also provides
access to the following user menu options: ALARM SILENCE, SENSOR RESET, DOOR ACCESS,
ARMED AREAS, SYSTEM TEST, USER CODES, SCHEDULES, and DISPLAY EVENTS.
Powering the 532XR
Your 532XR operates on standard 9V Alkaline batteries
that connect to a 2-wire battery harness at the back of the
keypad. A battery and battery holder are supplied as well
as some adhesive foam allowing you to attach the battery
holder directly to the back of the keypad housing. See
Figure 1.
Important: Unplug the 9V battery when not in use.
Three System Types
Area Arming
When first powered up, the 532XR displays
DEMONSTRATOR for three seconds and then defaults to
the Area Arming mode.
Pressing the Command key displays: ARM DISARM. The select key under ARM allows you to arm all
areas or any combination of the available areas. The select key under DISARM allows you to disarm all
areas or any combination of the available areas.
All/Perimeter
To enter the All/Perimeter mode, power up the 532XR while holding down the
far left select key. See Figure
2A on back. Continue holding the select key until you hear two beeps. The 532XR displays DEMONSTRATOR
for three seconds.
Pressing the Command key displays: PERIM ALL. The select key under PERIM arms just the perimeter.
The select key under ALL arms both the interior and perimeter. During the exit delay, you can press the
select key under INSTNT to instantly arm the areas.
Home/Away
To enter the Home/Away mode: power up the 532XR while holding down the
second left select key. See
Figure 2B on back. Continue holding the select key until you hear two beeps. The 532XR displays
DEMONSTRATOR for 3 seconds followed by SYSTEM READY indicating the system is disarmed or
SYSTEM NOT READY if disarmed with the front door loop faulted. See Front Door Loop on back.
Entering a valid user code while disarmed displays: HOME AWAY. The select key under HOME arms
just the perimeter. The select key under AWAY arms both the interior and perimeter. During the exit delay,
you can press the select key under INSTNT to instantly arm the areas.
Entering a valid user code while armed displays: ALL SYSTEM OFF followed by SYSTEM READY.
Armed Displays: The All/Perimeter and Home/Away modes both use the display PERIMETER ON for
perimeter arming and SYSTEM ON for full system arming.
Adhesive
Backed
Foam
B a t t e r y
Holder
Alkaline
9 V
B a t t e r y
B a t t e r y
Harness
Figure 1: Connecting a 9V battery
LT-0192 (1/96)
USER'S GUIDE
532XR Demonstrator Keypad
2841 E. Industrial Drive Springfield, MO 65802-6310 800-641-4282
