Spare mount bike rack
MODEL: BC-8407-2
INSTRUCTIONS
×1
×1
×1
×1
×1
×1
×1
×2
×1
×1
×1
×1
2
Install the connecting tube to the back plate. Caution: select
the right size of the connecting tube according to the chart.
3
Install the back plate onto the car. You may need to position
the back plate according to the position of the bolts.
4
Install the tire back to car. Tighten it with the nuts.
5
Secure the upper part of rack to lower part with
bolts and nuts.
6
Use the locking knob to secure the rack to car.
change
1
Remove the spare tire from the car.
Tire Width (read the size located at the side of your tire)
195mm-235mm - Use the short connecting tube
235mm-275mm - Use the medium connecting tube
285mm-12.5" (318 mm) - Use the long connecting tube
Some tires must require the use of connecting tubes with different sizes of these above. If you can not
tighten rack properly, then use a shorter connecting tube. On the other hand, if you can see the tick
mark line, use a longer connecting tube.
Caution: please double check that the tick mark line (shown with red line) is fully covered.
If it is not covered, please change to longer connecting tube.