![background image](http://html.mh-extra.com/html/derrica/u-6298/u-6298_user-manual_2485505001.webp)
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
* RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable
exposure condition without restriction.
User’s Manu
for
UHF wireless microphone
U-6298
U-6198
When you want to set-up a new frequency, please do use the AUTO Searching function by
pressing Set-Up key in 1 seconds of the receiver to search the best frequency around you, and then
press the Set-Down key for 1 seconds and put the transmitter IR close to the Receiver IR window, to
match the receiver and transmitter in same frequency.
Don’t just press the Set-UP or DOWN key to change a new frequency simply.
▲
2*100 Channels
1*100 channels
▲
Auto channel searching
,
infrared channel matching
▲
microphone (transmitter) can be worked with anyone of this
receiver