background image

SSP-100 Portable Speaker System Quick Guide

DD4941643
Rev 00
14 September 2021

201 Daktronics Drive

Brookings, SD 57006-5128

www.daktronics.com/support

800.325.8766

Page 1 of 2

This guide explains the setup of a Daktronics SSP-100 portable 

speaker system. Refer also to this short YouTube video:  

https://youtu.be/k-5YtyKJYlU

Important Notes:

• 

Do not use if wind may potentially knock down speaker/tripod! 

• 

Do not use in wet conditions! 

• 

Do not allow amplifier to get wet! 

Equipment Setup

1. 

Loosen the tripod leg fitting knob. 

2. 

Extend the tripod legs, and then re-tighten the knob. 

Note: 

Tripod legs should be spread as far outward as possible 

(braces parallel to floor) for best stability. 

3. 

Use the side handles in the speaker cabinet to lift it up, align the 

mounting hole in the bottom of the cabinet with the tripod, and 

gently place it atop the tripod. 

4. 

Use supplied power cord to connect the speaker to 120 VAC 

power and turn on the 

POWER

 switch. If using an extension cord, 

ensure cord is long enough that the speaker can be raised 

without pulling on power cords! 

5. 

Firmly grip the handle and loosen the height adjustment knob 

to carefully raise the speaker. The pressurized gas shock allows 

the speaker to rise with very little effort. Once at the appropriate 

height to reach the intended audience, re-tighten the knob. 

          

Leg Fitting 

Knob

Height 

Adjustment 

Knob

Handle

Reviews: