Daktronics FLR3-100, Installation Quick Manual

Page: 1 / 4

FLR3-100 Installation Quick Guide
13 June 2017
DD2291475
Rev 06 201 Daktronics Drive Brookings, SD 57006
www.daktronics.com/support
800.325.8766
Page 1 of 4
This quick guide provides steps for installing the receiver and setting up a FLR3-100 key fob with a
Fuelight
TM
Gen 3 display.
Installing the Receiver
1. Using a flat-head screwdriver, open the digit face to access inside
the digit cabinet.
2. Remove both antenna hole plugs from the digit face. Refer to
Figure 1 .
3. Place the receiver on to the mounting studs on the back of the
digit face. Refer to Figure 2 .
4. Use a
5
/
16
" nut driver to secure the receiver to the mounting studs
using the two provided nuts.
5. Place the threaded end of the antenna cable through the
antenna hole.
6. Place the flat washer over the threaded end of the antenna cable. Refer
to Figure 2 .
7. Thread the provided nut on to the threaded end of the antenna cable
and tighten using an
11
/
32
" wrench.
8. Thread the female end of the antenna on to the threaded end of the
antenna cable and turn the antenna clockwise until snug. Refer to
Figure 2 .
9. Connect the receiver cable from receiver to the driver. Refer to Figure 3 .
10. Neatly secure any excess cable with cable ties.
11. Close and secure the digit face.
Setting the Security DIP Switches
The FLR3-100 key fob has a series of dip switches on the back to give it a unique address setting. Set
these switches to a unique setting to prevent others from being able to control your display.
1. Remove the small cover on the back of the FLR3-100 key fob radio. Refer to
Figure 4 .
2. Using a paper clip or a micro screwdriver, set the switches to a unique setting.
3. Replace the back cover.
Antenna Hole Plug
AH
Mounting Stud
Figure 1: Digit Door Receiver
Mounting Overview
Receiver
Antenna
Mounting Stud
Nut
Digit Face
Nut
Washer
Figure 2: Mounting Profile
Figure 3: Final Receiver Assembly
Digit Cabinet
Driver
Receiver
Antenna Cable
Note: Do not change switches nine and zero.