Quick Start
D
ESCRIPTION
The Combo PON D2 Small Form-factor Pluggable (SFP+)
combines the 10 G XGS-PON OLT and GPON OLT optical trans-
ceiver into a single-mode fiber SFP+. The SFP+ provides a single
optical interface to a physical interface and provides an XGS-PON
and a GPON interface to the supporting system when installed
into an appropriate module or system.
Both the XGS-PON and GPON optical burst mode receivers
incorporate APD/TIA optics for maximum sensitivity. The XGS-
PON transmitter incorporates a 1577 nm EML laser assembly and
the GPON transmitter incorporates a 1490 nm DFB laser
assembly. The SFP+ is designed to support extended ranges
within the optical distribution network of up to 37 km. It is FDA 21
CFR1040.10 and IEC 60825-1 Class I laser safety compliant and
meets the EU RoHS Directive.
This SFP+ supports the following features:
■
ODN Class D2 (N2/C+) Transceiver
■
Data rates:
♦
XGS-PON 10 G down/10 G up
♦
GPON 2.5 G down/1.25 G up
■
XGS-PON Optical Receive Wavelength: 1270 nm
■
XGS-PON Optical Transmit Wavelength: 1577 nm
■
GPON Optical Receive Wavelength: 1310 nm
■
GPON Optical Transmit Wavelength: 1490 nm
■
Hot Pluggable
Applications:
■
GPON, XGS-PON, and Combined GPON/XGS-PON Access
Networks
■
Fiber to the Premises (FTTP)
■
Fiber to the Building (FTTB)
■
Fiber to the Curb (FTTC)
■
Fiber to the Distribution Point (FTTDP)
Due to compliance certification requirements, use only pluggable
optics supplied by Adtran. Adtran cannot certify system integrity
with other pluggable optics.
I
NSTALLATION
Before installing the equipment, inspect the SFP+. If damage has
occurred during shipping, file a claim with the carrier, and then
contact Adtran Customer Support. For more information, refer to
the warranty.
Installation Steps
To install the SFP+ into an appropriate device, complete the
following steps:
g
NOTE
Do not remove the protective dust cover from the SFP+ until the
fiber optic cable is ready to be connected.
1. Insert the SFP+ into the SFP+ cage on the module.
2. Slide the SFP+ all the way into the SFP+ cage until there is
an audible “click”.
g
NOTE
■
Orientation of the SFP+ will vary depending on the module.
■
The latch on the SFP+ is for removal only. When removing the
SFP+, rotate the latch away from the SFP+. It should easily
slide out of the cage.
3. Continue the installation and turn-up of the host module
using the instructions in the Job Aid or Quick Start provided
with the module or other system-level documentation
available online at
.
Adtran Pluggable Optics
Combo PON D2 SFP+
For OLT
April 2022
61442543F2-13B
P/N: 1442543F2
